Can you get a tee to connect the interface cable under the dash to the cable running to the multi function gauge?
Can you get a tee to connect the interface cable under the dash to the cable running to the multi function gauge?
BULLET 21XRS 250 SHO
What interface cable?
Depends upon the multi-function gauge.
If Command Link multi-function gauge, yes. If conventional multi-function gauge, no.
BULLET 21XRS 250 SHO
Without knowing precisely how your boat is configured I cannot say precisely what you need. There are components available from Yamaha that will allow the Lowrance to be connected to the Yamaha Command Link (aka NMEA 2000) network.
Take a look in this document. You may have to remove some components and then add some components.
https://online.flowpaper.com/7c250766/2019MRP/#page=10
The motor has command link gauges , I have the Lowrance interface cable, I have a backbone I am just trying to avoid running the cable back to the motor it's real tight going through the motor rigging hose and connector . I was thinking the command link gauges are already connected to the motor and they are under the dash so trying to figure out a connection tee to tie it in.
BULLET 21XRS 250 SHO
the gauges are connected to a connection that doesn't mate with the new Lowrance cable , there is a open slot on the speedo and two connections that have caps in the harness between the gauges nothing fits the Lowrance connection .
I was thinking that the motor connection must be used to run the gauges , I an trying to figure out photo bucket to post pictures
BULLET 21XRS 250 SHO
I think I need that white connector doesn't look exactly like either but similar parts and wiring.
BULLET 21XRS 250 SHO
Gateway hub assembly 6y8 81920-11-00 81920-11-00 thanks for all the help
BULLET 21XRS 250 SHO