Originally Posted by
wdr2064
I will just say I was disappointed at how difficult it was to rig my Vexus. The rigging tubes you are speaking about are dead ends. You need to remove the screws from the trim piece that is for your motor rigging tube on top of the boat. Push that up, push your transducer wire through there, remove the screws from the side panel at drivers seat area and push your rods or fish tape back it will come out at motor rigging tube. Pull your wire then push your rod through the tube near console and pull your wire through. Will require removing panel under console. Most difficult boat to rig I’ve owned and I’ve owned several. My AVX 1980 was way harder to rig than it should be.