Here are a few photos of my install of a pair of 8 foot Blades on a 2019 Z 518 L Ranger. First off was installing the brackets and with the detailed instructions it was pretty easy. Then the poles went on next with only doing it by myself it was a bit difficult but they went on without a hitch. My next step was routing the tubing, I looked at all possibilities and went with drilling through the plastic cover for the splash well access. All other areas had too much tubing and wiring behind the fiberglass and I just did not like any of the other possible areas. And with the extra hydraulic tubing if taking the splash well cover is needed there is plenty of tubing to take off and move to the side. Once I got the tubing to where I needed I used marine silicone sealant on the 4 grommets and remember to wipe off excess right away. The pumps I installed where the spare prop holder is and that gave me plenty of access to the pumps. I rolled the extra hydraulic tubing next to the pumps and loosely wire tied them in securely. I installed a Marinco 701 power switch and ran a 6 gauge power wire from the positive battery post to the switch and ran the two red wires from the pumps to the other side of the switch and the black wires to the negative post on the battery. Battery used is the starting battery. Next was running the air out of the units and programming the switches which was pretty easy. I put the dash switch on dash with 2 sided 3 M mirror tape and it is a very strong bond to the dash panel. Next was the foot switches on the front deck which you install where they are convenient for your use. I went with the starboard side to stay away from the trolling motor cable possibly hitting the switches. After the install I am very glad I went with the red Blades and another Thanks to Kevin at K&K whom actually sent me photos of the red Blade next to a Ranger paint chip of the red I have on my boat which was a big factor in my color decision. I hope this may help someone else whom my be installing Power Poles.