New bearing carrier seals. Butt seats redone
Troll motor tray, geiger-tek bridge mount
In hull transducer. Ran new wires for electronics, amd for sub fuse parts el for electronics.
Installed 7c7 seat bases over top r&r bases. New impeller
Ultrex.....
1995 Champion 190 dcx Elite
1990 Champion 184
Yamaha proV150
Garmin Electronics
I tried to run, new heavier Gage wires from my console to the bow today on my 95 190, I got about 3 feet up the PVC tube then something is stopping. Also going with a recessed foot tray. What did you do about the PVC up front?
who makes that front graph mount?
Geiger tec
https://geigerteccnc.com/
1995 Champion 190 dcx Elite
For those I didn't go through the PVC tube. Was packed already. I went around it. You can also fish the wires over the aux gas tank amd come out by the console .
As for the pedal tray, I had to pry the pvc tube away an inch or 2 for the tray to fit. It's only held on by a thing layer of fiberglass.
1995 Champion 190 dcx Elite
I also have a 193 DCX and would like to install (1) a trolling motor tray, mine is exactly like yours ) and also I need to change out the Livewell pump and would you have any pics of that. I would surely appreciate any information you could provide/ thanks in advance
20190408_160745.jpg20190408_185225.jpg20190409_195650.jpgOriginally Posted by jfunston
Use the template or make your own, I had to move a pvc conduit. I also had to cut down the v shaped fiberglass so the tray would fit amd take out a bit of foam
As for the livewell pulp, you could get away with just a cartridge replacement of its johnson pump compatable. You'll have to remove the batteries and oil tank
Last edited by RickCamilleri; 08-18-2019 at 04:40 PM.
1995 Champion 190 dcx Elite
Reply With Quote