Anyone have any advice on where to mount a si transducer on the cobra 201? Maybe some pics?
Anyone have any advice on where to mount a si transducer on the cobra 201? Maybe some pics?
This is how I mounted mine on my Jack-plate and no holes drilled in the transom, I used aluminum square tubing. Just make sure you have room on your Jack-plate mine is a 10” Jack-plate, I ran the transducer cable down the inside of it so nothing would ever snag it. This has work great for me. It’s not a bad option if you have the room also I have a through-haul transducer for when I am running on plane. I am running 998c & 898c as of now
290A6AEC-6494-4EE2-B7EA-799141DC546E.jpeg3818B83D-93DD-4029-BB81-47DE25BF8555.jpeg
Last edited by stickerjoe; 08-13-2019 at 08:41 PM.
1999 COBRA 201 DC
MERCUR 225 OPTI
What through hull transducer did you add for when on plane? I’m new to the side imaging stuff. I purchased a 998c and 997c and am trying to figure out what all I need. So far I’ve purchased two power cords, 1 hdsi transducer and 1 as grp antenna.
I believe it is a XNT 9 20 T - Transom Single/DualBeam Transducer, It is epoxied it in as for back as I could get it with out blocking the drain plug. You will also need a Splitter Cable ( 9 M SIDB Y - 9-Pin Side Imaging Dual Beam Splitter Cable ) I believe this is it, but check to make sure your plugs are the same. The gps I mounted with double stick tape to the back with no new hole drilled.
Sorry it took so long I was out bending my trolling motor prop shaft. I would say fishing but wasn’t too much of those getting in anyone’s boats that we had talked too.
C3BCC548-C655-46C7-BC05-68473853EADC.jpeg5BFB1FEE-11C8-4F71-BD54-FCA01B7034B1.jpeg469B7964-1C30-481C-9AB5-2E4B68039B0F.jpeg
Last edited by stickerjoe; 08-14-2019 at 05:17 PM.
1999 COBRA 201 DC
MERCUR 225 OPTI
Thanks. I’ll start gathering the parts.