Does the network cable power the graph?

[Smokinal]

I just finished a nice, clean install of a 106SV Ultra, 34 and GLS10. Went to power it up and nothing.
Does the network cable from the GLS10 to the graph power the graph? Because that's what the instructions show. I thought it was way cool that it did so I didn't need to run another power to the graph but I'm questioning this now.
And does it matter which Network port on the graph I plug the cable into?
Do both the GLS10 and the graph both need power?
I know, I know...don't spit out your beer laughing at me because I know this seems obvious; again, that's not what the directions show.

[wmitch2]

NO ! The GLS10 needs power from the Battery thru a switch. The LVS34 connects to the GLS10, then the GLS10 connects thru the Network cable to the graph. But, the Graph needs it's own power supply.

[tlefire]

The 106 needs it's own power source and either network port will work.

[Smokinal]

I knew this seemed too obvious.
Thanks for confirming.
Back to disassemble for the 4th time.
Should have this ready to go for the fall crankbait bite...