So I installed a 20amp regulator as what European suggested and all problems solved. Thanks European.
Type: Posts; User: rbreaux
So I installed a 20amp regulator as what European suggested and all problems solved. Thanks European.
Thanks European AM, I will look into the regulator you suggested...
European AM, thanks for responding. I know it’s a 16amp system, lead acid battery and the rectifier if I may draw a picture; resembles 2 triangles together with 3 posts to attach the wires. 534106
Leonreno, could it be too small if a battery (750) drawing too many amps when radio/amplifier are on getting the rectifier too hot and burning one side. All connections are and clean and new. I did...
I’ve used both OEM and aftermarket (Napa brand). They seem to do fine for a time or two and then start to spike again.
1996 mercury 2.5L FF block was EFI, removed and made a Carbbed motor....turn 6500 regulary, somewhat race stuff....the serial number was for the EFI set up orginally...It has a 16amp charging...
Thank you Joe 54......I am enjoying it much better than a 1999 fitch 175, LOL.....I will look into poppet valve advice.. i have to ask, what is an A45 TEMPEST prop?
So we had a project....I just bought the motor, I did not turn any wrench but had some input on upgrades.....The motor was a 96 2.5L 200 EFI. One cylinder was hurt but not scared. We opted to bore...
I'm not a guru on such, but I do know that a Tempest prop is a surface piercing prop by design. They are made to run high prop to pad...My 99 Triton TR19 with a 99 Ficht 175 is set at 2 1/4" and is...
So this weekend I did exactly what I thought I could do.....I swapped motors.....2 Screws and 2 new rubber seals later and the swap was made....While apart, I cleaned and wiped down all.....Checked...
Thanks bradrodfish, I do have that site in my arsenal.... but what i am after is just swapping motors in the hand control units.....I am googling any and everyone involved in troll motor repair and...
thanks redngoo, i too have 3, 1-12volt foot, 1-12/24 volt hand standard thrust and 1-12/24 volt high out put thurst hand....I am wanting to put the high thrust on my triton and was thinking of...
Good evening gentlemen.....Has anyone done or know if it can be done.....swap motors on an evinrude 12/24 volt hand control troll motor from a standard thurst to a high output....By just swapping the...
Yes, that's what I figured....I though moving down n diameter would give you less blade in the water etc....But I know the routine and we'll play with it....
Thanks, 21XDC
Im' going from 3 blade 14.25" prop to a 13.5 4 blade on a 6" jackplate, manual. Should I drop it to make up for the less blade length in the water?
Thanks, Roddy
prayers sent! and that she heals quick!!!!
thnks
An Evinrude 1999 175 Ficht, which runs great.....I have plans to replace motor but until I do, I thought I would play with this and see if I could get some difference between the Turbo 3 blade and...
Has any tried the original Turbo 1 prop on a TR19 with a 175hp on its back.....
Any comments or suggestions …...
Thanks Roddy...
I can not open site for manual.....looking for manual for TR19