I had a new 115 Yamaha SHO a couple years ago. I followed break in procedures exactly and it was an oil making machine. In researching the problem, I found that I was far from alone in experiencing...
Type: Posts; User: Tinny
I had a new 115 Yamaha SHO a couple years ago. I followed break in procedures exactly and it was an oil making machine. In researching the problem, I found that I was far from alone in experiencing...
Here's a trick to do it with a hole saw. Profanity warning.
https://www.youtube.com/watch?v=9-pBlZa1RBI
I don't leave it on the charger for more than a day. I like to put it on the charger the day before I go fishing. But I also have so much battery capacity that going two trips without a charge is...
The heading puck can go anywhere. Get a cheap magnetic compass and put it where you want the puck to go. Operate your trolling motor, main motor, or whatever else could interfere with it and see if...
My owner's manual recommends not using ethanol whenever possible.
I thought the same thing. I clicked on this thread thinking I was going to see a really cool installation.
I did that once when my engine wouldn't start and I had to limp back to the ramp. I trimmed my Ulterra up as much as I could and did a few practice stows to get a feeling for the timing. It went...
In addition to the other SeaArks mentioned, there is also the EasyCat. https://www.seaarkboats.com/boat/43/easycat
This is the ticket.
I agree about the bilge pump but why do you say not to put a switch on the outboard? I've never heard that advice before and I like having the ability to make sure the outboard power trim is...
What happens if a little of the green stuff gets mixed in with the dino?
For me the worst part of upgrading from Ipilot to Ipilot Link was the remote. That stupid touch screen is always going off when it brushes up against something knocking me out of spotlock. Yeah,...
If you can get all 5 batteries in your rear compartment that would work. If you put your electronics battery up in your console it's not as feasible.
I have this battery setup and I use MK precision chargers. I have a 4 bank in the back and a 1 bank in the console for the house battery. If I had to do it over again, I would go with a 3 bank...
4200 and a transducer mounting board so you won't have to deal with this the next time you change transducers.
54 Amp.
The 125AH Ionic didn't get along with my Suzuki 300. It cranked the motor fine the first two times and the alternator charged it from 70% to 98% during a couple hour new motor break-in cruise. ...
Hmm, I guess I'm back to where I started.
Thanks for the answer densik.
I have 3 Helix networked units and I've uploaded a bunch of saved waypoints to my primary mapping Helix. I've turned on sharing and all my other Helix units can see them. I got to thinking that if...
Is there a way that you can change it?
Does anybody make a cover or plug for the Helix cable connector tray to keep out dust and water when the unit is not connected?
Clean out and reseat your connectors before buying a new cable.
Last year I snagged something on a deep diving crankbait. It turned out to be iPilot remote, same as I used on my boat. It had been in the water for a little while as it had some moss starting to...
Thanks, I've been thinking about running a second fuse panel in the bow and also another one in the battery compartment all run with 6 gauge marine wire. I think that will make my life a lot easier...