Search:

my experience, you need a 6" jackplate to hit the 60mph range on the 181s

Going to watch this closely. I have the same boat and year and thinking of doing the same. Out here in calif. they are slowly squeezing our 2 strokes off the water.

AMEN!

Excellent!!!!!! really like your idea for the middle step box/seat!

I am by no means a boat mechanic, But I just installed a Seastar PRO in my 18' Champion and the measured path my hoses we to go measured 13' 4" I ordered 16' hoses and glad I did... just a larger...

I feel I should close this thread by THANKING!!!! those who responded to my questions. and that is exactly what I did, bought the Sea Star Pro kit with 16' hoses and installed it myself! (had help...

How would one get ahold of someone to ask about the Pathfinder?

Thank you!!!! 96 CHAMP That is what I needed.... someone to verify what length hoses, I could not decide between 14' or 16' long. now I have to do some shopping!

Thanx guys, I"ll check with c&c

My dual cable steering has finally gotten too tough to use safely. So I am looking into hyd. steering. I cant seem to get all the info I need from the local boat shops, They say bring it in and...

THANK YOU !!!!!

Can you trace the orange wire back to see where it goes?

I have one of those too. But I think it never had any type of cover.... curious to see what it does also.

Yes,too much money for the shape they are in. I offered him $ 100.00 delivered for one wheel, He declined.

I have a 97 181 elite and really like it but cant figure out how to mount electronics around the console?

Absolutely! that is sharp! I also would like to buy one if you would like to make another.

you were right, talked to Carol and she had them!

THANX!!! Tx Champ. now how do I contact them?

Anybody know where I could buy 2 of the 181 emblems that go on the sides of my boat?

I am looking for the short 16" Black power pole with the seat mount attached. to match the one I have in the back of my 1997 181 elite. It was made by swivl-eze with the snap lock mounting pin in...

Update, so as it turns out finding a real good outboard mechanic is the key! problem was minor slits in the back diaphragm on the accelerator pump.after replacing/rebuilding everything that bolts to...

ok I have an appointment with another marine mechanic, hopefully he can diagnose and fix my problem. forgot to list my prop Lazer11 21pitch

Thanx, I just spent $700.00 to replace everything fuel related no change.All 4 cyls at 145 compression I can only get 4000 rpm at full throttle,and stumbles coming out of the hole

Hello,I am considering repowering with a 4 stroke my 95 115 merc is just too noisey and runs too rough.Any suggestions would be appreciated thanx,rick

How do you remove the access panel on the front deck,to install electronics or tighten the mount for the trolling motor?