Search:

The car tires have a higher load rating than the Kendas did.

Check all the switches for operation. All 3 or 4 of them. See if it can be isolated to certain switch or if all then maybe the relay.

I didn't test with or without scenarios. Just stating I just don't have any issue with booting up this way. Everything comes right up after initial boot.

OK, didn't want to side track another thread. So, I'll continue mine.

It was said in the other thread that multi Helix's can share M360 over enet....But I cannot from Apex to Helix? Seems strange...

Yes, as long as the conductors are big enough, then utilizing 2C, Red/Blk, will suffice.

And when the series bond in the male plug is made for 24V, current has to travel the length of the bonded 2 conductors, therefore increasing the full length of said circuit.

549935

Again,...

To turn over the outboard? I would think the BMS isn't going to like it.

Then there's the common ground. Can cause inadvertent ground loops.

You shouldn't have a 50Ah connected for a jumper. I personally don't like the common grounds either, some have issues with that.
I just keep a jump-pac in the boat in case of emergency.

Started in 16' with 2 Battleborn 50Ah for 24V Ultrex on 05' 519VX. Traded in the 519 for my current 19' 520L, moved those 2 and bought a new 50Ah from battleborn for the 36V Ultrex.
Have 2 50Ah...

All 3 units of mine: 2-Apex 13's at bow and 1- Helix 15 at console have no issue with the VX Premium cards.
But, I have 3 identical cards, all in slot 1, so I don't have to worry about network boot...

Actually, current is the same across any point in a series circuit. By utilizing the jumper in the TM plug you in essence have increased the length of the feed conductor that results with an increase...

There is a pin that goes thru the bracket that can be moved lower. Looks like it's in the middle holes.

https://garzonstudio.com/old/boat/capacity-decal.html

Press the text 'Chart'

Splashwell, as they'll need to be some slack (loop) for them to move with the cylinder.

Some rollers use a steel thru bushing inside the roller itself and the bolt will rust to that bushing.

Tire size presently? I'm leaning towards 14"

Guess myself and previous owners got lucky, never a problem.

Doubt it's a fuse.
Put motor up a little, turn where it doesn't work...try every tilt sw. Motor, console, bow.

If it doesn't work anywhere look under the motor cowl.

Not that good....they were still deep.
I won't fish deeper than 30, not into fizzn fish.

Guess I killed the thread :eek:

��

Did it turn with the hydraulics connected?

www.etecownersgroup.com

Ground connection thru charger possibly. Remove charger leads and test.

USE IC2000