Awesome. Now we are cooking with grease. Thank you taking the time.
Type: Posts; User: crock1576
Awesome. Now we are cooking with grease. Thank you taking the time.
No. I need the rectangular aluminum "washer " that the snap ring and its washer slides on.
Do you recall what it is called?
Not available through this vendor. Must be a Ranger "thingamabob". I will try to send parts a picture. Thank you.
Thank you.
2010 520VX. This is the second time I will be replacing these rectangular "washers" that the snap ring and it's washer slides on. Poor design in my opinion. I think I found them on Ebay last time....
Does the 3-1 work with HDS 12 Gen2 touch?
I will make sure to do so. The tongue normally lifts off the ball with ease followed by my manually pushing the boat back a few more feet without any resistance.
I have a 2010 520 with tandem axles. Recently I have noticed that the axles/brakes have been stuck when I try to move the trailer. The tab at the tongue is not under pressure, although I push it...
Not to hijack the post but this happens to often to several members, most of which have a sufficient size battery. At times I have the same problem, or at least my graphs reboot on their own. Is it...
2010 520. Seemed to be lubricated enuff and Check all my boats a couple times per year. I may have taken that one for granted though. Glad she made it home. I will be more observant for sure.
I cant get the picture uploaded but you will get the message. Last night as I was getting the boat ready for today and began to swing the tongue back in place, it wasn't very smooth. I took a close...
might post this on the Mercury forum. there are some experts in that forum that have helped me several times. (not to offend my fellow Ranger buds)
I was told years ago that the 520 mold was updated at some point, and the 208 is the original 520 hull. Don't know how accurate that statement is.
ttt
New assembly on. Same brake pads. New rotor is so much harder to spin. I pushed caliper all the way back out. I assume it is because the rotor is new? Also, should I have used lock tight on the...
Thanks. Ordered the parts today. Will I need to bleed the brakes after? And by replacing these, will the alignment change?
Does the hub assembly come sealed and greased?
Just noticed that the passenger side front axle has grease leaking. Not sure how long this has been going on as the boat has been sitting since September as I have been out of town. Grease is just...
Thanks guys. I appreciate the advice.
I have the opportunity to purchase a friend of mine's 2006 Tundra. The truck has extremely low miles and I have known the man for 23 years. He is obsessed with his equipment. Safe purchase and...
Fellas,
Gotta go out of town for a few months, and once back, odds are she is put up (in the garage) until February. Remind me of any storage routines you go through annually. I usually top of...
I installed it in my step. Large drill bit to create the space for the tools to slide thru. I cannot recall the manufacturer of the tool holder. For some reason I want to say it is a Bass Cat...
it could tear like paper
Good question. And if I may piggy back on this one. Will someone please give a brief summary of each function of the switch? From dead cranking battery to the other locations on the switch and...