Also if I buy the download, can I load on both devices?
Type: Posts; User: joho5
Also if I buy the download, can I load on both devices?
Thanks Todd! Is it better to get card or buy the download?
Have the 73CV at trolling motor and have 93SV at helm...both chirp models.
I notice their contours aren’t quite as detailed as say Navionics webapp in like creek channels and certain areas. To the...
It'll show contours on both...or just one or other with new software?
I have two units on my boat. A 93sv chirp and a 73cv chirp. Well on my 93, the "fishing" chart has zero contours. The 73cv, the "fishing" chart has the most detailed contours. What's up with that?
That worked. Got my wife to hold the button while I poured and it sucked up all it needed
Thanks
Ok finally got all my seals on and figured it all out...upon reassembly, I cant get the unit to run right.
the relieve valve was open when reinstalling and when I got the unit put back on the...
Ok got the tilt and trim unit off, ram out but I can't figure out how to get either end of the ram off so I can replace cap seals.
Does either end screw off? And if so how do you vice it to screw...
Acutally, I solved the issue. I reached wayyyyy up in the gunwale and found a tube! empty, for this. So once I got my wire snake in the tube, it pulled right through.
I have a Ranger R72 and trying to install a Garmin Echomap 93sv. Ive done this process several times on a few different boats and have never been able to not get the plug wire end of my unit from the...
Awesome...thanks
This may turn this from a $200+ job to $20
From the looks of it...I think I can tackle it.
As far as getting air out of the system when I put it all back together...Do I...
What do you mean? Can just pull ram out?
Can I leave the tilt and trim assembly on the boat...disconnect the top of the ram with the motor and prop motor up and just remove ram?
Or do I have to pull the whole assembly off the boat? If...
What's the cost to update an old one.
I can't find anywhere else to ask this...but how big off a difference is the GPS actions on the older ones vs new ones?
Small amount of fluid is leaking around where the ram moves up and down. Like the area the shaft slides.
Easy fix? What do I need to do?
I just bought a used boat and was checking out all the lights and there were a couple clearance lights not working. One has a bad ground I believe, because I can switch the snap in light with a...
Pedestal out as in the pole? Was going to try and get a wire adapter for my drill and clean it.
Just bought this boat used. Both the spot where people put a deck extension as well as the front but seat, the poles I had to get a pipe wrench to loosen up and it was still a task.
Its sooooo...
I have a 96 Ranger R72 that has a decent gel coat on it now. It shines and I want to make sure it stays that way. I plan on maybe using the 3M stage 2 plus wax product once a year or so to keep it...
I'm.assuming this is easy to find and see under there? Where do you get a replacement?
sometimes when I turn the key, it gives me the normal beep...sometimes it doesnt.
It really doesnt bother me that much, but just making sure this wouldnt also be the alarm sound for something...
yep got inside the valve and it was trashed inside.
Replaced the flaps with the kid along with o-rings...havent put back in boat, but bet its good to go now.
I do fish tournaments but more of a methodical slow type of fishing. That's why I like the spot lock. Anchor up fish sn area and then use the arrow keys to move 5 feet at a time.
Would a 12v 55lb trolling motor pull around a 17ft Ranger adequate?
My old boat had an XI5 and I loved it. Was looking at them and noticed the 12v 55lb model is quite a bit cheaper than the 24/80.