Check out Xometry for part manufacturing, and prototyping. I have used them many times with great success.
Type: Posts; User: mudron08
Check out Xometry for part manufacturing, and prototyping. I have used them many times with great success.
I have purchased many things from rock auto, never had an issue, however I never purchased spark plugs. After seeing how cheap they are, I am inclined to think about purchasing a few to try.
World Wide Marine for me, just had a claim this winter. Policy was through progressive. Never once did i have to argue anything and it was all immediately taken care of and paid for. Total payout was...
I think your looking for Mercury Part#859769R03
So I installed the new pump, I installed the compressor hose and the feed line on where indicated by the instructions given with the new pump. The rest of the lines I put where they would reach. I...
Do you know if that has changed with the new style pump, as that is not in the manual and was not provided or mentioned in the updated instructions with the new pump? The only lines called out...
Mercury Optimax 225 sn#OG927739
Hey all, I am installing my new oil pump and I am wondering is there a “firing order” for the hoses when they get connected to the pump?
Also, after everything...
519955Does anyone know if the oil pump test on the diacom software is the same as an oil pump prime sequence as shown in the picture?
I am also south of Pittsburgh, check your messages I will PM you my cell if you get that far, and are interested let me know. I am in a similar circumstance also trying to find where it is leaking...
Do you think if I shop vac the oil out after each time I prime the system I could get away with it? The reason I ask is, I am thinking of using the prime sequence to find my leak and to verify its...
Thanks Joe!!
When you prime (with diagnostic tool), do you have to do anything else, for instance will there be an excessive amount of oil after priming assuming that there was still oil in the plenum and such?
Hey Moneyshot,
I believe the below part numbers are what you are looking for, not sure exactly the difference between the two though.
519829...
That was one of the first things I checked, no blisters just some scuffing from the old bunk carpet that I wont worry about. I had several nicks in the bottom of the hull from unloading into the...
It’s tough to see but there is cribbing 2/3 of the way to the bow also.
I lowered the nose of the trailer to the floor with a floor jack, then placed the cribbing you see under the jack plate and raised the nose back up as high as I could with the floor jack. Then I...
Hey All, I got the trailer out from under the boat this weekend to do a bunch of work to the trailer and to patch a couple nicks on the bottom of the hull. Just figured I would share some photos and...
Would it be frowned upon to place a hose over the brass fitting that is in the manifold and connect it to a brass elbow that would replicate what was installed originally? If the brass elbow is...
Thank you, Joe. I will see what I can find.
I found the crack in the elbow. It was open enough to fit my finger nail in it. Is the brass piece threaded in or press fitted? Also could anyone point me in the right direction for a service manual?...
I plan on removing that elbow this week once I finish another project on the boat. I tried finding a new one through Mercury but to no avail, I’ll probably end up doing the same as you if it’s...
What would you recommend resealing with?
Oil pump is dry, most of the oil is located on top of the intake manifold around and near that white elbow. Would this leak more at higher rpm?
Thanks for the idea, I have one and will try it out once I get it all cleaned up.
Serial number: 0G927739
So I have oil leaking and i am going to clean and degrease the engine this weekend when the weather warms up, but I have a suspicion that the oil is coming from a...