I have 24p Fury on a 02' zx225 Skeeter with a EFI 225, this weekend ran 66.8 5900 rpms. I can go over 6000 rpms WOT with no speed increase. I was around 20lbs wp. Do I need to drop down to get more...
Type: Posts; User: rayzrbck
I have 24p Fury on a 02' zx225 Skeeter with a EFI 225, this weekend ran 66.8 5900 rpms. I can go over 6000 rpms WOT with no speed increase. I was around 20lbs wp. Do I need to drop down to get more...
Where can I find the wiring schematic diagram for this boat please!!! My power panel has gone out!
How do you reset the panel?
I have a 02 Skeeter zx225 and my push button power panel went out. I contacted a dealer and he said there was a recall on this particular panel and have switched to a rocker panel. Of course I never...
Around 72-73 I know its not a huge difference. The biggest thing is the rooster tail is so low and do not know why.
I have a 02' skeeter with a vmax 225 efi 12" jackplate, I put a Fury 24p on recommended by this board. Ran the boat yesterday 70 mph @ 5900 rpm wot. The rooster tail was below the cowling and if I...
Hooken mine has done the same since I purchased the boat. When I get on it runs fine, just happens when I ease into it. Midnight I did clean the housing.
Checked the pumps and a little fuel is coming out of the small hole when I pump the bulb. Does this sound bout right?
Motor is hesitating a little on initial take off, runs well there after. Any ideas? I've changed the plugs and cleaned the o2 sensor. Just seems like it gets a little to much fuel then leans out and...
Thanks for the info.
Zx225
I still have lost speed with this prop any suggestions?
Yeah I thought of that and did notice it jumping around the other day.
I have a 02 skeeter with a yammie 225 efi 12 inch jackplate. I used to run a yammie 25m prop and thru a blade. I now run a Fury 24p and I'm running 6800 rpm's and running high 60's which I know is...
flat u are the man, thanks!
I know nothing about the vst tank..location or what to do, walk me thru it please..thanks for the info guys! Photos if possible.
Having a terrible time bleeding the brakes, any suggestions...
Everything is back in and I am having a problem putting back the snap rings on http://www.bassboatcentral.com/smileys/mad.gif Is there a trick to it....Thanks
Trying to change my solenoid on my 02' ez loader trailer, can someone walk me thru it, looks easy but just want to make sure?
thanks buzz http://www.bassboatcentral.com/smileys/smile.gif
I have a 02' yamaha 225 ox66, bought it about 2 years ago. I have had no problems(knock on wood). I run seafoam thru every tank of gas, should I clean the o2 sensor or just leave it alone til...
Shifting into gear it runs rough, when I give it gas runs great. It also idles great when it is not in gear. Could it be a linkage problem? Any ideas...
I will check and get back....
I have a 02 zx225 yami 225 efi 12" jakeplate 25m prop. When I get it up around 70 mph it starts chine walking pretty bad. I try adjusting trim but I just have to back off. Is my jackplate too...
2002 zx225 02 efi 225
water temp 50 degrees
.25 quarters tank
2 people
3 blade m-25
12" plate
76.8 gps
51 air temp
2 strokes love cold air WOW!...