Thank you Mark! Hope your fishing trip vacation goes well and I’m glad I was able to make you day.. Sherm
Type: Posts; User: shermsmarine
Thank you Mark! Hope your fishing trip vacation goes well and I’m glad I was able to make you day.. Sherm
I know we are all sick n tired of dealing with Covid and the effects it has had on everyone and everything. It's a shame that it has to once again effect one of the BCB events and this IO is a really...
The shift linkage is improperly connected after impeller change. You have to sync the linkage to the lower unit with the shift linkage above..
Yes your oil pressure will vary some depending on the oil temp.
What type of alarm? Beep beep or long solid beep?
I'm not a Ranger guy but if the motor was just serviced and all found to be good to go then I'd try a 24p Tempest on it.. That should get you very close approx.4650 range.
Well this isn't easy to know for sure the correct answers but if your rig has been setting for a while the rotors will rust and what you have may be normal. The rotors will rust from sitting then the...
The 2004 is a bolt in console so it could be removed but they didn't offer the removable console option used today.
We will be in the Columbus Fishing Expo starting Friday at Noon- 8pm .. Saturday 10am-7pm, Sunday 10am-5pm in Columbus, OH.
Displaying the BCB Pantera Classic, Caracal and Yar-Craft 186TFX, 209TFX...
I'd recommend a Fury 3 24P from all the rigs I've ran and set up.
Ok sorry, I didn't realize you had a AE without compartment lights and the original A10..
I'd recommend you go to the terminal panel on the transom and ck and clean all the grounds and positives on it.. I have found most issues are there and not the A10.. I often times find corroded...
Chances are it's not the panel but loss of grounds.. Back on the transom you have a terminal block that has all the grounds and also positives. I'd ck all the connections on that panel first for...
The new panels will tick if you shut the master power switch off and have a lighted compartment open after a few minutes on. The lights will go to flickering that matches the ticking timer in panel....
It’s nothing. It is the timer in the new touch control pad that replaced the A10 panel that controls compartment lights.
The capped wires out the front are for gauges. Merc offers a harness that goes from the control box to the gauges. Temp gauge isn't really going to work but a water psi shouldn't be a problem to add..
Yes it will
Triton bass your fine right here just try to give us as much info as you can. Can you tell me what prop your running?
You won’t really need anything to convert to the 08 60. They both use the same harness/cannon plug, T&S Cables same
It’s really simple. When it’s trimmed up your effecting the fuel systems design. First it changes fuel level in the carbs bowls but the biggest reasons they are more difficult to start trimmed up is...
Any Mercury dealer should be able to get you the 200 decal
I just set up a new Cougar FTD with 250ProXS V8.. Atlas Hyd. JP, Dual 8' Blades, Ultrex 112, so 4 Batteries, 1 Full fuel Tank other 3/4 Full, Live wells full and my fishing gear.. I started with a...
If you trim up near full trim and your only at 3500 RPM range as mentioned yes I've had customers this has happened to.. Your loosing water psi and motor overheats. Basically what your doing is just...
You mentioned only getting 52 mph... What RPM is your motor turning at WOT? You defiantly have something going on.. Your PII should be a high 60's- 70 ish MPH rig.. I'd recommend getting it checked...
I have sold both the 3" & 4" trailers under the Classic.. Have had no issues at all with the 3" frames w/
14" tires but as for looks there is no doubt the 4" w/15" tires just looks a whole lot...