The frustrating part is that we bought a boat made in Pensacola Florida, and we live 5 minutes from the Bullet Factory.
Type: Posts; User: mossyoak76
The frustrating part is that we bought a boat made in Pensacola Florida, and we live 5 minutes from the Bullet Factory.
I would have been fine if he had just owned up to the mistake, and said sorry they couldn't do anything because of the age or something like that, but to give me a bull$#!% response saying that's how...
Well I checked with Blazer, and as I figured from hearing about Blazers horrible service, the response I received from Keith Craft was " sorry about your luck". He then proceeded to tell me that is...
Hey guys, I have a 2004 190 PROV. Started replacing the carpet, and when I pulled the floor drain cover realized that when the hole was drilled for the drain cover they missed the pvc drain pipe at...
Who around Knoxville, or down toward Lenoir City would have some Props I could possibly demo. Before I drop $500 on a new one that won't work for me. Do you know anyone up around my area that may...
What about trim angle and attitude of a Blazer? The reason I am asking is, when I go up more with my motor my amount of trim past the neutral trim state will be less because my water pressure begins...
Would raising the motor not cause more slip? Also I am above Mercury recommended RPM already. When I can get hold of some Trophy props. I am going to tinker with it some more.
Finally had a break in the weather today to get out and run the blazer since installing the 5deg negative wedges. Holeshot cured.
25p TEMPEST
Almost 2 3/4" below pad
63mph GPS
5900+ rpm
I do have a steady tell stream. I seriously think my smartcraft WP readings are less accurate than my analog. Do you have any experience with the early smartcafts Rebel?
If I remove the 1 plug my prop has in it now, It just blows out trying to come out of the hole. Since am only running 1 plug with the large hole in it could I still be venting to much, and causing...
Water pressure seems to be an issue. I have a smartcraft sc1000 on the boat and according to it I'm under 12psi. My analog WP gauge is saying I am closer to 20psi. I'm not sure which one to trust....
2004 190 prov DC
200 EFI MERC
10" SLIDEMASTER
25 TEMPEST PLUS 1 LARGE PLUG
2" below pad
65 MPH GPS WOT
5700 RPM
PLANES IN A DAY AND A HALF
Added 5deg neg wedges, but have not tested them yet...