Search:

Type: Posts; User: Infishicated

Search: Search took 0.00 seconds.

  1. Replies
    206
    Views
    4,803

    Ronald Reagan!! The best in my lifetime thus...

    Ronald Reagan!! The best in my lifetime thus far.:salute:
  2. Replies
    6
    Views
    539

    Haha, yes this is the photo from several years...

    Haha, yes this is the photo from several years ago when I brought her home for the first time. That boy is hooked on bassin now and never wants to stop when we are on the water. I bought it used,...
  3. Replies
    6
    Views
    539

    Whats it worth?

    I have a 2009 20X3 pro w/ 250 PROXS (low compression @ cyl #1) dual poles, agm batteries. What is a fair asking price?
    495059
  4. Replies
    6
    Views
    1,053

    I am leaning towards repowering with a new...

    I am leaning towards repowering with a new 4stroke, but the 60+ week lead time is tough to bear. What is y'alls opinion on my current motor value for parts as everything minus the block and one coil...
  5. Replies
    6
    Views
    1,053

    Update to my woes, took it to a local Mercury...

    Update to my woes, took it to a local Mercury dealer. I had a bad coil #4 and low compression in #1 cylinder. This explains my loss of power this past year. looks like water got into it #1...
  6. Replies
    6
    Views
    1,053

    Thanks Don, I was in the process of checking the...

    Thanks Don, I was in the process of checking the spark plugs and saw oil leaking down from the compressor under the pulley. Could this have an impact on my performance. Is this an early sign of...
  7. Replies
    6
    Views
    1,053

    Motor Struggles

    Engine Serial # 1B736246 2009 250 PROXS approx 282 hours.
    2009 Triton 20X3, 10" bobs jack plate, dual power poles, and 4 agm batteries (3 bluetops troll, x2 group 31 for starting/electronics)....
  8. Replies
    13
    Views
    1,003

    I have a 20X3 and need to replace them one of the...

    I have a 20X3 and need to replace them one of the locking hand pulls broke. What I have found is these.
    click on link, Boat seat slide
  9. Replies
    4
    Views
    408

    I found my short, the wire is chaffed right near...

    I found my short, the wire is chaffed right near the connector. My question now is how do I go about with repair? Do I have to order a new harness ( which I do not see a part for, just the coil...
  10. Replies
    4
    Views
    408

    Here is my second attempt. If it doesn't work,...

    Here is my second attempt. If it doesn't work, code is “201-1 fuel injector 1 circuit 1, The ouput signal from ECU to device is open circuit or has to much resistance.”

    429372
  11. Replies
    4
    Views
    408

    Fuel injector fault

    Where do I start to resolve this issue, I looked at the connectors and wires and do not see visually any concerns there.

    2009 250 PRO XS SN# 1B736246, 242 hours

    429282
  12. Replies
    10
    Views
    600

    Do you have a jack plate? I have the same boat...

    Do you have a jack plate? I have the same boat except I am running a 26P fury, and a 10" Bobs action jack, Dual 8' PP Blades. With 4 blue tops, 3/4 fuel and a ton of tackle I run about 68-69 before...
  13. Replies
    1,194
    Views
    556,944

    Sticky: 2009 Triton 20X3 PRO, 250 PRO XS / FURY 3 26P on...

    2009 Triton 20X3 PRO, 250 PRO XS / FURY 3 26P on a 10" Bobs Marine Hydraulic jack plate,36 volt MG Tour Junk (upgrading soon)
    425746 425747 425748 425749
  14. Recommened Jackplate setback on 09 20X3

    I have an 2009 20X3 pro 250 ProXS/26p fury on a 10” manual jackplate. I am going to install a bobs action jack plate. Should i stick with the 10” offset or decrease/increase? I have not seen much...
Results 1 to 14 of 14