ChanpioNman, Seahorse? Any insight?
Type: Posts; User: tiggerwoods
ChanpioNman, Seahorse? Any insight?
Anyone?
just looking for a little help.
Thanks.
Hi all
I spun the main bearing on my 200 vindicator and have the opportunity to purchase another motor and use the powerhead. My question is: would the powerhead from a 1996 Ocean Pro 3.2 L V6,...
I tried a 23 and lost the main bearing. Waiting on having it rebuilt and will sell it.
What would you suggest, a 23p to start? Thanks for the reply, much appreciated.
Hi Guys
its been a while since I posted but I need some advice and this is the best place to go.
I have a 1998, 196sc with a 200 Vindicator and a renegade 25 pitch 4 blade prop. I just added 2...
Thanks hulapopr. That’s the one, much appreciated.
Anyone have an answer for me? I need one but I need the m
name first.
Hi Guys
whats the name of that cigar like tube that holds the timing idle screw. I need one and can’t seem to find a name anywhere.
Thanks,
She came out of the garage today. Water as soon as it thaws, woohoo!!!!!!
Close to 11/2 feet of snow last night. It’ll be quite a while before she gets out of the garage.
It’s -15 Celsius and all lakes are still frozen here. My 196 is locked away in the garage with new Talons and a Helix 7 G2N
Mine holds 43 gallons.
She runs even better now. Test run complete and I'm one happy camper.
Hi ChampioNman
thanks for the advice. Finally pulled the cowl and found a loose clamp between the filter and pump. Also found that the pulse limiter had separated. Repaired them both and will...
Hi champioNman
the bulb is correct.
If it was an air leak would it be before of after the bulb?
I'll look at the anti siphon valve after eliminating the leak.
My last resort will be to...
Hi all
i went out for a run today and got up to 71 on gps with an empty Hydrasports 196. On my way back to the cabin toe motor started to act as though she was running out of gas and then died....
About 2" below pad
Yes I am trimming it up as soon as its on plane and the motor is a little high, I'm currently working on prop to pad placement whin
le maintaining adequate water pressure.
Hi All
i hope all is well and life is treating everyone good.
I have a 1998 Hydra Sports 196SC with a 200 Evinrude Vindicator and a 6" manual jack plate that I recently added. The problem I'm...
Thanks ChampioNman.
When checking the carbs I noticed that #5 was not opening all the way because one of the screws on the linkage was loose, should I have them synced?
Thanks for your help, I'll order one from the dealer today. My drain plugs have already been changed, they have a slot on the end instead of being rounded.
Hi Guys
i have a 1998 200 Vindicator E200STLECE, I was told to change the #2 high speed orifice to two sizes higher or from 67D to 69D because of a design flaw. Is there any truth to that and if...
Hi All
I am looking for some carper for my 1998, 196 SC. It is burgundy with black hints through out, can anyone tell me where to buy some? No offence, but please don't recommend C&O, they don't...
No response so I ordered my things online, no discount I guess.