That worked, thanks
Type: Posts; User: mwh624
That worked, thanks
Changed prop on my L6 verado, tightened the prop nut to 55ft/lbs.
When I spin the prop it rubs in 1 spot, not spinning freely. Is this normal?
I'd assume not.
Does it indicate a hub not inserted...
Good to know the length. Thanks
Thanks I'll chase it back
526482
526481
Hi,
I just got a new boat that came with a MercMonitor gauge.
When it boots up it says Level 3.
I was planning on setting up a NMEA 2K network to link graphs to my engine, but in looking...
Just out of curiosity, does your Fuel Economy read correctly? Oddly, that's the one thing that still won't compute correctly on my 12 G4N, despite the fact the unit will tell me the motor burn rate...
The NMEA 2000 on Humminbird has been a huge disappointment. I was hoping the G4N units would be an improvement but they seem no better than my G2N units.
Is what the unit is showing for amount...
To answer your original question, yes 9 is a huge improvement over a 7 and a 10 is a noticeable improvement over a 9.
Agreed Humminbird doesn't do the best job conveying all the information.
You might want to find the source of your interface.
Try starting with everything off and only turn on the megalive. ...
+1
I added another unit to my console so i could get full screen SI+ and split 2D/DI+ on another screen.
Just note, with the new Mega+ SI transducer, I had to add the separate 2D transducer to...
Your problem is going to be when you have a fully charged battery. Better to run it through a step down transformer that you can pick up off Amazon or eBay for cheap.
Different chemistries have different nominal voltages as we as different discharge voltage profiles.
As batteries age they can become less efficient, putting more load on the other battery they...
You should only connect similar batteries of the same chemistry and age in parallel.
Truth be told Humminbird PC is a terrible program. It is functional, but leaves a lot to be desired when it comes to the ability to easily organize and categorize waypoints and tracks.
That said,...
My setup:
Yamaha F150xb
NMEA 2000 Backbone
Yamaha NMEA interface cable (not sure if the SHO has the same interface, I assume it would).
Free Ethernet Hub port
Humminbird NMEA 2000 black box (for...
Make sure you have good fusing if you are powering any low voltage electronics off 120 VAC.
100%... Humminbird's waypoint management is terrible. I always end up exporting them into Garmin BaseCamp which allows you to graphically manage waypoints into groups, then import back into...
Yeah, I'm asking about the opposite scenario
I was curious if anyone has successfully setup a G4n unit on a NMEA 2000 network with the adapter cable and confirm if it does share the NMEA 2000 info...
Do G4N units share NMEA 2000 information over ethernet? I have a Helix 12 G2N, Helix 10G2N and a Helix 9 G1N and will be adding a Helix 12 G4N.
Since you can plug a G4N unit directly into a NMEA...
I can display Low-Q 2d from a G2n Mega SI on my G1 Helix 9 GPS.
Personally I'd look to replace the Gen 1 unit as the Gen 2 units have much more potential
Updated the trolling motor software, see how it works next time out
I've got a Helix 10 Mega si g2n on my
dash along with a helix 12 mega si g2n and a helix 9 GPS g1n, all networked together, along with my terrova.
Ran into a weird issue today. Used my helix 9 to...
I'd vote going with the 100ah LiFePo4 for a electronics battery if you can afford it. That would get you 80ah per day of usable power.
You could always add a DC-DC charger to supplemental charge...