Thanks Fred, I did the 5 turns plus 1/2 turn and it did help but issue still there. Shall I go ahead and turn out another 1/2 turn?
Type: Posts; User: javelinbass
Thanks Fred, I did the 5 turns plus 1/2 turn and it did help but issue still there. Shall I go ahead and turn out another 1/2 turn?
It's definitely shows 225 on the motor, its a 225hp engine. I want to reset all the idle jets to original. How many turns ccw out is it? 5 or 6?
Thanks Fred hope all is well
Hey guys, looking for a little help. The model is J2256TLE26. So she's a little difficult to start but eventually I get her going. After letting her warm up I put it in gear and she stalls right out....
WhT type of thrust washer do I need to use a 24P Turbo prop? Thanks!!
I run XD 50, I DO NOT cut corners on anything when it comes to my outboard. Now that being said I replaced the primer ball and walla!! It’s running good on the hose, need to water test ;)
thanks...
lol I get the hint
Fuel lines were changed out at one time. I was thinking the same thing but don’t believe thats the case..
Hey guys long time. Picked up a 95 201 for 2,500 thats been in storage since 2013. Anyways just hung this motor on it and the motor will not stay primed. She will idle for a few minutes but then...
Hey guys, looking to go to a 4 blade prop. What do you all recommend? What kind of numbers will be looking at?
Thanks!
After Columbus day?
I have one more trip to plan this year and I want to head way up north. When should it be prime time for fall small mouth fishing up there?
Good Evening Gents, just a quick question. My motor will show blue smoke every once and a while. It won’t happen at startup but after a few stops fishing. It randomly happens and the motor runs fine....
What should I expect? I’ve never fished up there this early in the season. Will the bass be in pre spawn of will they be spawning? Thanks
2005 Stratos 201 with the slider tongue typ trailer. I’m trying to remove the slider portion and I’m stuck! I removed the first pin easily so it would drop down. The second pin in the back is...
LOL thanks
I’m going to attempt this on my own. I see theres a compression collar the sits above the impellar. How do I remove / replace that collar? Do I need a special tool? Any potential issues I may run...
thanks!!
I’ve replaced both low pressure fuel pumps and all the filers except the “mystery filters”. I think I may send the injectorrs in for service. I just need the courage to remove the fuel rails ;). I...
Same thing with my 05 250 HPDI. I still can’t figure it out. She also smokes a little at start up. I’m changing the plugs to see if that helps.
Just found out the cheap plastic ring is cracked causing my gauge indicator not to work. Thats a tight area back in undrr the motor. I can’t find any vids on how to change it. Any imput would be...
Where could I purchase these pistons?
Run good gas in her and change out the fuel fiters every 100 hours. I use ring free and yamalube and its been a good motor
Someone told me the trim and tilt piston are starting to wear on the power trim motor. They said this will allow water in and eventually ruin the pump. I’ve never heard of this but I’m not a know it...
2005 201 Pro with Yamaha 250 HPDI with
hydraulic jack plate...
I love the layout of this boat. There are two things I do not like but I can live with...
Rod storage box's seam smaller than my...
pm sent