Your VST needle may have been stuck. It will dump fuel at the mid-section of the motor directly into the water.
Type: Posts; User: 06champ198
Your VST needle may have been stuck. It will dump fuel at the mid-section of the motor directly into the water.
What is the best wood and carpeting to use for bunk boards? Also do you need to glue the carpet down in addition to using stainless steel staples? Boat used in fresh water only.
Thank you
Rich
2006 225 Pro XS model year
number-number-1B362470
This is addition to another thread I had started. Thought everything was fixed. I will be replacing the fuel line from the tank to the bulb...
Appreciate the great input. The issue was caused by the technician. In this particular case I was right. There was nothing wrong with the boat before they worked on it. All the problems I had were...
Thats Geat info. Thank you for the feed This boat ran great before. Why would I need to run my boat after maintance? No running issues issuea at all prior to maintenance. I drove over 180 miles...
2006 225 Pro XS model year
number-number-1B362470
Quick back story. Boat ran fine late October. Had maint scheduled with my dealership Match 10th. No running issue. They performed the...
2006 225 PRO XS model year
Serial number-number-1B362470
Dealer performed maintance today. Motor has 252 hours. They did plugs, water pump and fuel filter and throttle air gap. Thank you Don...
Thank you Don.
I run all three Mercury treatments all year long. Also use DFI oil.
Model year 2006 225 PRO XS
Serial number-1B362470
270 Hours
Owned this boat since new in 2006 and it always has this little stutter I guess while in gear. Just lived with it. If you give it...
You talking about the radius tie wraps? Regular tie wraps will not seal properly, and you will have a leak. It would also depend on where you plan on using the tie wraps but if it had a tie wrap on...
I suspect it would run great. Would be a beast with the SHO 250 Flashed.
I went from a 2000 186 to a 2006 198 just for this reason you mentioned. Needed more room and fishing some pretty rough water at Lake Of the Ozarks in Missouri. Fishes great. Rides good and I can...
My 2006 198 Dual axle has the shocks. You can tell a major difference when you are on a very bumpy road. You get a much better ride and I compare that to my last trailer that did not have shocks. ...
26 Tempest plus worked by Marc Croxton. They are really a turd out of the box. Out of two you have there I would say the 25 Tempest. I run that as my spare but the 26 is so much better.
I have a real heavy duty cover now. I keep the boat on my boat lift from about April through November but it is a pain in the rear end to get on and off. Does a great job however. Anybody have a...
I did mine. What a difference. Looks brand new.
198. Just the right size. Does everything well.
I have same boat. I prop open the rod boxes and the back compartment with a piece of 2x4 to let air move. Not too bad but has always done this since new.
Tri-lobe pin. Had same thing happen to me.
If you have it provide your serial number. It will help assist with the answer and Don will want that information.
Exactly what I did. 26 Tempest Plus worked by Mark Croxton. Transom wedge and a 10 inch manual slide master. 67 to 68 loaded.
Thank you
Could this be a compressor issue possibly? I say that because of the rattle I heard and the motor just has a different sound. Not like a sewing machine like I call it.
Thank you. I will check that. I believe the insert you are talking about is on port side correct below latch I think.