Thanks man!!!
Type: Posts; User: eaton30
Thanks man!!!
Anyone know where I can get one before I put a hole or scratch my boat?
site won’t let me post a pic for some reason.
Ok thanks for the reply. I’ll get the serial in a bit.
here is the serial
0A970944
Hey guys, I have an 86 Skeeter Starfire with an 86 XR2 motor. that I’m trying to sell. It was running good one day the I take it out a week later or so and when u push the throttle to go it bogs down...
Hey guys I can't find that anode on that site either. It shows the same diagrams.
Thanks guys !!!
Ok where can I get them. Cause I dont remember seeing them on the parts list
Isnt something supposed to be there?
Guys I have a prob. My motor bogs down when I give it gas when the lower unit is in water. I noticed an opening at the tip of the unit and it seems to be trying to dump exhaust and some gas thru it....
Ok I gotcha. I appreciate it.
Ok to get it right when u say the fill cap that is the cap at the top left side that comes through a hole. I have another spot on the right side about middle ways down. Isn't that a vent port or...
Right under the motor
Right under the motor
Yes i did.
O and it says there should be fluid pressure when motor all the way down but it's the opposite. It has pressure when I raised the motor all the way up. Maybe that could be a problem. I hope the guys...
I got my cylinder back and I installed it. Put trim fluid in it. Won't raise or lower. Is there a proper way to get it to work.
Ok that sucks. I'll get on it whenever we get out from under all this rain. I didnt see a small pin but i wasnt looking for it. Appreciate the advice. Thanks.
Anyone
Ok I got the top pin out now the bottom has 2 Allen screws I can't really get to. How is that bottom pin supposed to come out.
Thanks
Haha BFH... gotcha. Thanks guys.
Ok gotcha. So it must take quite a bit of force to knock the pin out and break the tri lobe pin. I'm a mechanic at work and tried using a punch couple weeks ago and was not sure that was the way it...
I saw the pin ur talking about. My question is its hard to get to. If I tilt it up I can possibly get to it but can I knock it out from the back side of the motor. Any advice welcome. Here is the...
It's a 150 hp by the way
I have a 86 xr2 where if I tilt the motor up it will leak down. I have bought the oring kit for the cylinder and my question is how do I take the top bolt out to get the cylinder off.
Thanks
More like warehouse haha