These tow units have been networked together and working fine for three months. All of the sudden both of them are having a problem.
Type: Posts; User: BlueRanger
These tow units have been networked together and working fine for three months. All of the sudden both of them are having a problem.
I could be wrong on the Gen, it could be a Gen 3. It has been working with the 3n1 transducer for at least 3 years. The About screen shows
HDS-9T
Version - 4.5
Application 52.1.75
Platform...
I have a HDS Gen 2 touch and a HDS live networked together. The sonar on the HDS live and the Gen 2 Touch were working fine and now the Live unit will not work. The HDS Gen 2 Touch the sonar is...
Goo Off Professional worked well for me. Put it on let it sit for a minute and scrape off with a putty knife. I had to do it twice on a couple of the spots with a lot of contact cement.
My 1999 200 EFI quit sounding three beeps when I turn the key on. I applied 12V to the sounder under the dash and it would not beep. What is this part called? I need to order a new one.
You can try to push it through with an air compressor. Use the attachment iwth the trigger and use tape to make it the same size at the hole to try to push it through.
I used goof off professional and a flexible putty knife and the old glue comes right off.
I am going to get a free-standing boat lift and am wondering if anyone knows the weight of the hull, engine, gas, batteries and gear. I checked the specs pages and the hull weighs about 1520 pounds....
Goof off professional strength. Worked on the carpet glue when I replaced my carpet.
New seats were about $850. I did not get an estimate to redo the existing but I think it would have been about $600. Looking back I should have just reupholstered the existing. I had to fabricate a...
They are really nice. LLebroc makes them, high quality and very helpful with sending vinyl samples.
Put new carpet and seats in my old Ranger. I did it when I had time and estimate it took al lot longer than it thought it would.
Use flathead bolts and nylock nuts. I just recarpeted my entire boat and replaced all the rivets with nuts and bolts. I also put a strip of aluminum on the inside of the lid to add support for the...
I have 99 R91, 200 EFI with a 25 trophy plus. Hole shot is good and i get about 65 top end, 5800 rpms, by myself with a half tank of gas.
Its a good solid boat. I've had mine for the last 13 years and have no complaints.
You may have to put a narrow support in between the existing hatch and the new one. That will give you something to attach the hinge to.
There should be a ground buss under the console. It is basically all the grounds under the console tied together. They should all have flat spade terminals on the black wires and they will be...
I just replaced mine without a hotfoot and the 12 foot worked perfectly. I think the standard is to add 3 feet for the hotfoot.
Order placed. Boat and truck will be a lot brighter.
I had the same problem last year and it was a bad switch on the engine.
I have a Trophy Plus 25 pitch 4 blade on my 1999 R91. It tops out at 65 with just me in the boat.
I got mine on ebay. There are two different sizes so make sure which one you have before ordering.
Bounce dryer sheets. I put one I every compartment and have never had a problem.
They make cleaner for pontoon boats and I think it is called Toon Bright. Check with your local pontoon boat dealer and see what they recommend.
Make sure you get stainless steel staples.