Morning all
Type: Posts; User: Bronzeback
Morning all
Anyone know if you can pull the upper crankshaft bearing assy without splitting the case?
Found the top crank bearing assy bolts are loose. What would cause these to become loose and would this mess bearing up? What are my options now new bearing seal assembly? Can you remove this or does...
Thanks ChampioNman I will do that.. I was doing some more checking and the one side of the T oil lines the wire tie is loose. The T is dead center behind the air box under the flywheel. Could this...
544127544128544127544129
Model E250HGLABG
SERIAL 05467413
Doing 2nd 3 year service and pulled engine cowl and see oil what looks to be coming from under flywheel. Motor has 225hrs. It's like a black sticky black...
As the title says. Currently have 106sv abd was looking to go to 126sv. Units for livescope only. Seeing some not happy due to a grainer picture. Was just thinking going to the 12 inch screen with...
They had a great thing and started changing them and not near what they were. Wish I had a bunch of old originals to repaint
So what do you do with out of date electronics. I have some gen 1 and 2s that's not worth much. Have a couple I use on my stump jumper pond boat and on my track sled for gps.
Or does everyone sell...
Pm sent on gen 3
Does the caliper have a Chrysler symbol on it? My 97 calipers came off of a 97 acclaim same as pads. Hub I got from ranger
Thanks same thing I am seeing.. No one has measurements for the eye to the shank centerline.. Buddy has some mustad light wire that I think will work.
Making a custom walleye jig mold that have larger head size and looking for a 90 degree jig hook that has the eye to shank longer than normal jig.
Any recommendations?
Thanks
Chad
rojoguio
Been crazy busy but took all your advice and followed all you have said. Did repair skin first then cut/ground out transom and replaced with Coosa. Reinforced back to G10 Board and...
If I get the core transom out from the skin (.250 inches) and cut g10 board back approx 6 inches to grind, what or how are we thinking of attaching the new core coosa 26 to the g10 stringers. The...
We're it attached in front of transom where the bolt is has epoxy I'm guessing that oozed out of joint. 482577
So basically the strength of this transom comes down to the two .250in 90 degree bends within the laminated transom one on inside of stringer and one on the outside. Plus the 120 degree bend of...
Cap were I cut is 31 inches wide total cut about 44. Not sure what you mean by making a tooth. Where cap is over transom was sealed with a clear flexible silicone. Where cap sirs over hull looked and...
482556482557
Cut out to access otherside of stringer
I wasn't impressed either
PM replied
trying to pm you it only gives me option for url.. not real savy on getting pics on this site.
Here is a closeup of the right side of transom standing behind it.. Notes of where movement has occurred or delaminate
482500
Got some pics..
482490482491482492482493482494482495482496482497
Little setback on project. Caught a sinus bug. I have to cap cut and removed. I will get some pics up of what I’ve found. Rojoguio thanks for the offer but I already purchased probably way more than...