Search:

Yes he is still pouring. He moved to another state several years ago. Find his products on Facebook @ Paul Krew "Custon Hand Poured Baits"

Thanks Moonlighter for your reply. I was provided a copy of a service bulletin about the 3 to 4 inch level. I used the old style muffs however I did not left the water run as you suggested and I put...

Finally got the motor back. When I purchased this motor the dealer was suppose to go over a check list however it was not done. It was several weeks before I took the boat out, so before leaving...

I replaced the air restrictor plate with the proper one for a 20 HP. I reinstalled the original 9.9 parts and it still went into limp mode. Currently in the shop with a 3 week wait for service. ...

No flashing of light, burns steady. I think you are right about limp mode. I have another ECU that came on the motor (9.9) I replaced with the (20 hp) ECU up-grade. The motor has ran fine for 3...

No key, pull start. Thanks

Header should read 2021. Motor has about 6 hours and never had any problems until today. Started motor, always one pull, let it warm for several minutes and then idled thru a no wake zone. Applied...

I installed it on my boat and noticed it did not have a torque Tab or even a place to install one. No prop torque on these motors??

Thanks

I have an inline clear fuel filter under the cowling. The filter has very little fuel in it at idle ( fills when I prime the bulb) and when I raise the RPM it does not to fill. Motor runs rough at...

I have 2 props that were given to me that were on a 115 Johnson OB.. What other HP engines will these also fit?

Thanks

Thank you .

A friend gave me a new Stiletto which I can't locate the pitch or diameter. It has the following numbers on the hub 24419 01319 Any help?? Thanks

Anyone been to the river over the weekend. Just wondering about the water. High low muddy clear???

Thanks for the info I will check

Need to purchase a 9.9 HP motor for a aluminum boat. I was told that an upgrade (not sure what part) to the 9.9 Suzuki can increase the HP. Can anyone enlighten me if this is true and what part...

Is this motor suppose to have a neutral stater switch? If so where is it located. Will start in gear.

Thanks

Thanks for the info. Going to go South.

Anyone know the condition of the river. The gauge reads like 18.3 feet, which is high I believe. Planning on going in the morning. Thanks

Purchase the above motor several months ago and first time out the motor had a vibration at idle and thru the boat when running, alum boat. Replaced the prop thinking that may have been the problem,...

Really???

Purchase the above motor several months ago and first time out the motor had a vibration at idle and thru the boat when running, alum boat. Replaced the prop thinking that may have been the problem,...

It has a 9.25X10 on it now turning 5140 WOT, thinking on putting a 9.25X9. Always had big boats and usually will get about 500 RPM with a pitch change, same with little motors???

Thanks

It has a 9.25X10 on it now turning 5140 WOT, thinking on putting a 9.25X9. Always had big boats and usually will get about 500 RPM with a pitch change, same with little motors???

Thanks

So, a 9.25 X 10, 8 spline is the same for J or J1 or no letter.

What does the J1 on my prop mean. Notice on line some have just J and some have nothing.

Thanks