Has anyone here repowered their 199 with a Mercury 4-stroke? Please share:
- What prop you are running
- RPMs
- Top end speed
Type: Posts; User: Igor Reiant
Has anyone here repowered their 199 with a Mercury 4-stroke? Please share:
- What prop you are running
- RPMs
- Top end speed
Has anyone here repowered their 199 with a Mercury 4-stroke?
Please share:
- What prop you are running
- RPMs
- Top end speed
Much appreciated! Thank you all!
Considering to get a Denali XL or a Suburban in a few month. How's towing on this vehicles? Thank you in advance for the feedback!
I am selling a Stealth 1 Lithium charging system - $175 shipped ($150 if local pick up).
CHARGE ON THE RUN and get longer battery life, more power, and healthier batteries!
System consists of...
Anyone used NOCO GB70 2000A jump starter to jump 125Ah IONIC batteries? Or any other jump starters for that matter?
Supper Clean! Love how clean you did the wires!
I was able to consult with Jerry from Ionic, as well as a good number of outside experts on the subject. Now, while I got a whole lot of education on this subject recently I am not an expert by any...
Finalized the test of all 4 batteries. At appears that 1 of 4 batteries is able to charge to 14.4v without going into HV error. During the test i was watching very closely to determine when the HV...
Yes! From what I am told the BMS should be balancing the cells. In my case I see them balanced most of the time, and they start to get off balance when charging above 14.2v and further you go the...
I tried charging each battery individually with a portable LiFePO4 charger to see how they behave at full charge, where it’s full and at what point I may get that High Voltage error. I tested 2 out...
I am running Mercury 225 ProXS
When you say "it would send the battery into alarm" what do you mean by that?
Hello!
I ran my 125Ah cranking and 3 X 50Ah trolling batteries for the first time last week. At the end of the day 1 my cranking was at 98% and trolling batteries at 60%.
* I was fun fishing...
Bass Boat Technologies just added a link to order battery trays on their website - IONIC Battery Trays
373953
They have not posted them on their website yet! You can contact Van through Bass Boat Technologies website! He'll take good care of you!
Hello all! I recently purchased a set of IONIC batteries and faced the same challenge as many of you - how do I mount them? Sure you can put fillers in a traditional trays, or you can bolt a few...
I can't seem to figure out why in some areas, or some depth zones the depth readout is showing incorrect depth. If you look at the image I m in about 9-10ft but depth readout is showing almost 20ft. ...
I have a Legend 199 with 225 Mercury, and looking to get a set of Talons.
Can anyone advice on 10 ft vs. 12 ft.
Thank you!
http://www.bbcboards.net/attachment.php?attachmentid=240304&stc=1
Legend has a bit of a unique construction in front of the bow eye where you can’t use BowSheld.
Bow Roller is eating get coat
My bow roller is eating away the gel coat where the boat lays on the roller.
Is there any way to prevent this?
...
Take a look at this: Set of 2 Bass Boat Deck Caps Ranger and Other Boats New Read Ad for Dimensions | eBay
I am replacing the carpet and debating if I should add the padding to the uppers decks or no. Could someone advice on pros and cons?
If it happens that carpet is too tight on the lids you can always trim it. I replaced the carpet on my previous boat 96 Ranger and went with 24oz and had to do some trimming (I used hair clippers)....
Problem SOLVED! I called Mercury and they walked me through the calibration. You have to set TANK 2 to not installed!
Problem SOLVED! I called Mercury and they walked me through the calibration. You have to set TANK 2 to not installed!