I have the same issue on my ultrex. I use a black sharpie to dim the brightness.
Type: Posts; User: Bap71469
I have the same issue on my ultrex. I use a black sharpie to dim the brightness.
I am repowering my 09’ A211. Do you know if they had to use a wiring harness extension for your boat?
Thanks guys. That fixed the gap. I appreciate all the support on this project! I learned so much about the engine by doing it myself.
2008 250 Pro XS 1B734982
I am in the process of replacing my motor mounts and noticed a light film of oil on the compressor, just below the end cap. I pulled the end cap to determine if the...
Don, as requested, I have uploaded a couple of videos to YouTube showing the exhaust plate, swivel pin assembly and driveshaft housing. In the first video, I am pushing on the back of the exhaust...
Hey guys....got the XS plate in and when I went to bolt the swivel bracket to the upper mounts, I have approx 3/4” gap between the end of the swivel bracket and the mounts. Was I supposed to swap the...
Awesome.....thanks Don. I’ll be reaching out to her tomorrow. Thanks for all the feedback guys. I feel a lot better about the direction I’m headed now.
What XS motor s/n should I use for reference when ordering the plate and other parts? I would like to start working with Rhonda or someone on putting together a parts list.
Interestingly enough, no bolts were sheared. Just the front lips of the clamp and plate. Mounts were beat up a bit as well.
I agree with you on the thin casting. Pretty puny.
Thanks for the advice. I’m doing the work myself because it looked fairly easy to tackle. I want it done right, so I will start looking for XS setup. Guess I’ll try to sell the Pxs plate that’s on...
I'm going through the same issue on a 2008 Pro XS (1B734982), but my Pro XS has solid mounts in it already. Maybe this has been repaired once already under warranty? (I bought the boat in 2013)...