Search:

Type: Posts; User: skeeter03

Page 1 of 6 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    1,280

    BAK makes a nice trifold. Had it for my sierra...

    BAK makes a nice trifold. Had it for my sierra and know hqve one on my f150. No leaking issue and seams solid for the3 years it's been on
  2. Replies
    5
    Views
    787

    Check yamaha web site as they have a performance...

    Check yamaha web site as they have a performance section with a bunch of boats and there setup. They may have it listed there or something close to your boat and motor setup.
  3. Replies
    15
    Views
    2,499

    When i bought my battleborns I called them to...

    When i bought my battleborns I called them to order and they gave me a better price then they had on the site. Doesn't hurt to ask.
  4. Replies
    41
    Views
    2,081

    Ranger first then nitro. If you go with nitro...

    Ranger first then nitro. If you go with nitro check the flood in front of seats and drain. Had to rebuild soft floor that had rotted away. They used small pieces of wood and fiberglass over it. Water...
  5. Replies
    146
    Views
    21,592

    Can you pm me the price of 12 volt 50amp...

    Can you pm me the price of 12 volt 50amp batteries. Not sue if going 24 or 36 volt setups as I’m looking into a ghost trolling motor.
  6. Replies
    2
    Views
    328

    R&R eladder. They have one that mounts to the...

    R&R eladder. They have one that mounts to the mounting bolts of the motor.
  7. Replies
    9
    Views
    762

    Installed mine after I bought the boat, 6or 8...

    Installed mine after I bought the boat, 6or 8 bolts that came with it and used 3m double adhesive table instead of the epoxy. Been in 4 tears and rock solid. If I decide to remove will be less of a...
  8. Replies
    1
    Views
    233

    Vf175 SHO prop advice

    Looking for prop that will give me better hole shot and carry better. I have a t1 15 1/8 22 pitch correctly 6150 rpm at 3-1/4 below pad on a Skeeter03 tzx190 with duel talons. I trashed the t1 prop...
  9. Thread: SHO Break-in

    by skeeter03
    Replies
    7
    Views
    2,366

    My 175 made oil verified by oil samples. They...

    My 175 made oil verified by oil samples. They need to be hard to heat them. I don’t have a lot of hours on it due to small lakes. Last oil sample had 1.5% compared to the first at 3.5% @23 hrs on it....
  10. Replies
    1
    Views
    365

    Have 2016 tzx190 175 sho with t1-22 with duel...

    Have 2016 tzx190 175 sho with t1-22 with duel talons and run 62-63 3-3/16 ptp 6150 rpm’s and been thinking of having the 22 reworked to a 23 as I have hit the rev limit a few times running. I think...
  11. Replies
    4
    Views
    771

    My 16 tzx190 the same as 2019 zx190 with 175 sho...

    My 16 tzx190 the same as 2019 zx190 with 175 sho motor with 22t1 prop with duel talons loaded does 62-63 by gps. 65 before the talons were added
  12. Replies
    8
    Views
    710

    Get some fuel line and a barb fitting to connect...

    Get some fuel line and a barb fitting to connect to your fuel line of tank. I attach a bulb at the end of it and pull off after you get fuel flowing. Much faster free flowing it then pumping it with...
  13. Replies
    17
    Views
    3,622

    Check oil level often, if you notice it rising...

    Check oil level often, if you notice it rising drain oil out and add new oil. don’t just drain some off to get the level correct.
  14. 10' talons extend out to 10 ft. On hard bottom my...

    10' talons extend out to 10 ft. On hard bottom my 10 talons hold at 8 ft of water reading from my trolling motor transducer. That is about 20" deeper then the bottom of them. If you mount them lower...
  15. Thread: Boat cover

    by skeeter03
    Replies
    4
    Views
    389

    Coverquest.com also has custom ones

    Coverquest.com also has custom ones
  16. Thread: Boat covers

    by skeeter03
    Replies
    12
    Views
    618

    Try coverquest.com, sumbrella material has worked...

    Try coverquest.com, sumbrella material has worked well for the last few boats I had
  17. Replies
    16
    Views
    1,062

    My 175 sho turns 6100 running a 15-1/8 t1 prop 22...

    My 175 sho turns 6100 running a 15-1/8 t1 prop 22 pitch, different boat, so 23pitch would be a good start.
  18. Replies
    3
    Views
    584

    Have duel talons mounted on my skeeter with...

    Have duel talons mounted on my skeeter with 6"slidemaster. Bolts up no mods needed.
  19. Replies
    10
    Views
    665

    I used heavy duty trailer wire I got on amazon,...

    I used heavy duty trailer wire I got on amazon, has a shield around all the wires.
  20. Bill would you sent the PDF to sketvtx@gmail.com....

    Bill would you sent the PDF to sketvtx@gmail.com. Thank you
  21. Replies
    9
    Views
    547

    When I sold my last one to someone in NY in 2011...

    When I sold my last one to someone in NY in 2011 he needed a copy of the registration that was on the boat at the time of sale. It may have been CT didn't title boats at that time.
  22. Replies
    8
    Views
    731

    Had same problem on my 16, did one side and put...

    Had same problem on my 16, did one side and put lock tite on it. next night nocked the other side loose tapped the wrench with a hammer and it came free. I tried for days before I did this to get it...
  23. Replies
    5
    Views
    727

    Have all in charge in currant boat and last one...

    Have all in charge in currant boat and last one also. First unit went bad and wasn't charging but that was in 05. Was replaced and still worked in 15 when I got a new boat and added one to this one...
  24. When I added Talons to by boat I ended up light...

    When I added Talons to by boat I ended up light on the tongue. Moved winch post up 1.5" and made a huge difference towing.
  25. Replies
    5
    Views
    417

    I mixed up a little epoxy and coated the drilled...

    I mixed up a little epoxy and coated the drilled out hole to seal the edge. Not sure if it was needed but didn't want water to absorbed into the glass.
Results 1 to 25 of 150
Page 1 of 6 1 2 3 4