disregard post
Type: Posts; User: bbuckeye
disregard post
Any vegetation in toledo bend ?
looking for boater not yet registered for ky lake bfl on 2/24 I am on waiting list as co-angler and can get in if I find a boater.
Thanks for your input . What do you suggest?
Anyone know what size wire (AWG) the jumper from the battery to the switch is ? Also is the 8 ga. wire SHIELDED to block out any interference from other power sources. Thanks
sides of the rod lockers
I have a 2004 50hp 2 stroke complete with controls starts and runs fine don't know how many hours but not a lot, Replacing with a larger motor. Motor will be at Jacos Marine in Lawrenceburg Tn. soon.
Got what I needed . Thanks for replies
Anyone know where I can find a Sierra (Sahara) water pressure gauge model # 61870 ( 2003 520 Ranger). I've looked all over the internet w/no luck. Thanks
I have a used Bobs 6in. hydraulic (pump and fluid tank fit inside boat) Took off of my 2003 520 Ranger when I repowered in 2020. You will need up/down switch for steering column. 500.00 cash. pick-up...
Looking for ideas on a custom crappie rod 9-10 ft with some stiffness . I have 10 ft. B&M jig pole(way to limber) also have a BPS float-n-fly rod 9'-6" also to limber. Want to be able to lift...
TH MARINE finally responded. Z-LOCK JACKPLATE can be used with all v-6 and v-8 engines up to 300 hp. Thanks TH MARINE.
Did that.
Mine was a piece of junk (was installed correctly ,no binding or kinks ) cable broke in one of the 90 degree bends on the plug end after 6 mos. of use. They wouldn't stand behind it.
Received a new TH MARINE jackplate 10 days ago (model # JPZ 4 DP Z-LOCK manual) TH MARINE website states this jackplate will handle all V-6 & V-8 engines up to 300hp. The installation instructions...
What prop (4 blade) would be a good comparison to a Fury 4 23 pitch. 225 Mercury 4 stroke on a 2003 520 Ranger , no jackplate. Thanks
Recently repowered with 225 4 stroke.Trim gauge from my old Evinrude not working. I am considering replacing with Smartcraft 1000 which would give me trim gage plus water pressure , tach ,speed, fuel...
motor mate all the way, if motor is down securely on mm it can't bounce. Transom saver puts shock from the road on lower unit,thus traveling up the motor to transom. Todays transoms can handle either...
bassangler88 I'll give it more time, but I'm not happy with it at this point. Might end up doing whole job over.
Jaco's Marine Laweranceburg Tenn hands down
I've got a 225 evinrude if that will due you any good
I used the same thing ( it even states it can be used on fiberglass that is roughed up ) when it gets wet the carpet gets sticky ( like the glue is breaking down and coming through the rubber backing.