Search:

Type: Posts; User: 201pro

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Should be able to just put on recirc and run the...

    Should be able to just put on recirc and run the main pump and it does not take in lake water. The valve needs rebuilt or the cable has slipped.
  2. Replies
    5
    Views
    210

    Brucato is $150 for a set of 6 HPDI injectors....

    Brucato is $150 for a set of 6 HPDI injectors. You have to pull them and reinstall them yourself. Don’t know what a shop would charge to pull and install.
  3. Replies
    15
    Views
    208

    You need a fuel pressure gauge. It will have fuel.

    You need a fuel pressure gauge. It will have fuel.
  4. Replies
    80
    Views
    4,801

    Super clean will take off scum line and yellow...

    Super clean will take off scum line and yellow from the dirty water, better than anything I have tried to date.
    But it also takes off the wax, so need to rewax after use. But great if it gets...
  5. Thread: Patoka level.

    by 201pro
    Replies
    18
    Views
    1,038

    Apparently, a super dry July and low water levels...

    Apparently, a super dry July and low water levels doesn’t allow them to drop the lake? That’s all I can come up with.
  6. Replies
    30
    Views
    1,124

    Every boat is diff. Just go out and try it. Trim...

    Every boat is diff. Just go out and try it. Trim down, hammer it and see what the rpms do.
    Should spool up to around 3500 rpm. If too low, give it a little more venting. If too high, plug off a...
  7. Replies
    29
    Views
    974

    Did you look under the cowling to see if the...

    Did you look under the cowling to see if the shift mechanism is moving when you are moving the shifter?
    Next step would be pulling the LU to check the shaft.
  8. Replies
    6
    Views
    378

    Is there enough extra tube on the other end to...

    Is there enough extra tube on the other end to cut off the broken end and slide it up and inside the cowling.
  9. Replies
    11
    Views
    660

    Are you sure the older tilt helm isn’t the play....

    Are you sure the older tilt helm isn’t the play. It’s a pretty common issue. Pull the wheel and the plastic cover and put the wheel back on and look inside the tilt helm when the wheel has play. You...
  10. Replies
    16
    Views
    772

    You can get 30”x20” adhesive rubber mats on...

    You can get 30”x20” adhesive rubber mats on Amazon for $35
  11. Replies
    10
    Views
    562

    Tanners creek in August is my favorite time...

    Tanners creek in August is my favorite time there. I usually have my highest weights that time of year as long as the water is stable. But the baits are pretty simple. Like said buzzbait, small...
  12. Thread: Patoka level.

    by 201pro
    Replies
    18
    Views
    1,038

    Give it a try and report back to us.

    Give it a try and report back to us.
  13. Replies
    5
    Views
    325

    Looks like we are going to rent a cottage on one...

    Looks like we are going to rent a cottage on one of the chain lakes. Can fish all week and still close enough to my race to not have to switch to a hotel.
    Thanks.
  14. Replies
    11
    Views
    660

    Do you just install it? Sounds like air still in...

    Do you just install it? Sounds like air still in the system even tho you have bled it. Or the tilt helm is loose. Is it a new tilt helm also?
  15. Replies
    30
    Views
    1,124

    I trim mine different than Finlander. Mark will...

    I trim mine different than Finlander. Mark will tell you the same thing. My 201 needs to be trimmed really high at first, then once at speed, I bump the trim down a few bumps. It lets the hull get...
  16. Replies
    5
    Views
    325

    I don’t care about busy. I would be there all...

    I don’t care about busy. I would be there all week, so will have plenty of room.
  17. Replies
    5
    Views
    325

    Sept fishing around Madison.

    I have a bike race at the Trek Bicycle Factory in Waterloo on Sept 20-22. Would like to pull the boat up and find a lake To rent a cabin and stay for that prior weekend and week up until Friday. ...
  18. I only worry about mine if it doesn’t smoke on...

    I only worry about mine if it doesn’t smoke on start up.
  19. Thread: Patoka level.

    by 201pro
    Replies
    18
    Views
    1,038

    At 151cfs release, that’s not a short straw....

    At 151cfs release, that’s not a short straw. That’s the dam shut down. That is less release than when the rivers were all out of the banks.
    Would think they would at least get it down to allow...
  20. Replies
    8
    Views
    403

    So you have used HCT and they did you bad?

    So you have used HCT and they did you bad?
  21. Replies
    25
    Views
    1,837

    Just weld will work, until you use it. You...

    Just weld will work, until you use it.
    You either need to have it welded back or grind it smoother and run it. Welding is best option
  22. if not the interference that SoonerFan asked, you...

    if not the interference that SoonerFan asked, you need to check your chart speed. Fishing on TM, I use 1 or 2 for scroll speed. Any more and it gets all washed out/smeared.
  23. Replies
    2
    Views
    197

    I just have someone bump the starter with the...

    I just have someone bump the starter with the kill switch pulled.
    Usually slides right in. But have use your strap method before if no one around to help.
  24. Thread: Patoka level.

    by 201pro
    Replies
    18
    Views
    1,038

    Patoka level.

    Why is Patoka still sitting so high? They have the dam pretty much shut down. Seems like they would be drawing hard like Monroe is doing right now.
  25. Replies
    16
    Views
    423

    O2 sensor.

    O2 sensor.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4