Search:

Thanks,

So in the summer I should probably occasionally when stopping at the next spot open back up and turn to on to refresh with what is hopefully cooler water.

Something I'm not used to from my previous boat, but while on plane in the 20FX my livewells will empty.
Is this something I have to get used to and remember to close the switch before moving...

Wow, thanks for the quick response Hchamberlin1, and thanks for the link as well.
Tight Lines!

Rene

I had one side of Dexter Axle Brakes go bad. They really took care of me along with Skeeter Warrenty.
I have two complete HUB/Rotor sets now.

How are are they to change?
I do regular brakes all...

Thanks Everyone, Do you know if the dealer work is covered or just the parts.
I will also ask Skeeter.

Thanks Again,
Rene

Does anyone know the Bearings and Seals for FX20 Trailer.
I noticed I have grease on the inside of one of my wheels which means I probably had a seal go bad.
Bearings are probably OK.

Thanks,...

Meleagris1, thanks.

Thanks wbrown, so sounds like no concerns with separation. :-)

I've noticed on my 2018 FX20 the right rub rail has 3 bulges where it looks like the rivets/bolts (what ever is used) are pushing against the rub rail from underneath.
Not sure if I bought it this...

Does anyone know how to zero the gauge when all the way down? (atlas jackplate)

jdlefty3, thanks. I was out Saturday trounament load, two people. and I had it up to 12 and it ran just fine. I was very surprised.
Next time out I will bump it up a couple more notches. Since I'm...

Thanks, that sounds like a good way to handle it.
I think I will measure it the old way just to get an idea of what the number is around 3 inches.

Then I will follow what you have described when...

I bought the boat 1 year used. I have no paper work on the Jack Plate Setup.

First, How do I zero the gauge on the Jack Plate adjustment at the console.
My old boat was manual Jack Plate and I...

Looking for the same info. Did you ever pick one up?
Thanks,

Thanks for Posting the products and where I can order them.

Rene

I have the FX20LE trailer with the custom wheels.
1. What Lugnut type does the trailer use?
2. What Locking Lugnuts do you recommend?

Appreciate the help.
Thanks,
Rene

Thanks, I did notice the speakers were too big bgibson, I also shopped the Polk and figured I would order those.
Was cutting the holes and routing wires tough?

Thanks,

I have a Skeeter 2018 FX20
I have a sonic hub I would like to install according to how the factory has done it.
I don't want to pay a shop to install something that should be simple.

Could...

Thanks for the tips.
TomM - I wish I saw your reply one day earlier :-).

I just ripped the old ones out of the floor (Chipped away bondo they use to level the old Swivl Eze bases) and then took a...

I did try something similar, but now I have waited too long and they are frozen in. I've tried the floor jack on the deck, pip wrenches, etc.
Still can't break them loose.

I'm so tired of them I...

1997 Viper Cobra
As most of you know those of us with Vipers and Champions have seat post that stick really bad.

How hard is it to replace the stands, and what is a good stand to use.

I don't...