Elite 7 Fits on my 2003 2100 with the trolling motor up. The unit has to almost lay flat.
Type: Posts; User: Triton77
Elite 7 Fits on my 2003 2100 with the trolling motor up. The unit has to almost lay flat.
I'm pretty sure the exhaust is below the waterline...
Thanks Flounder! Both were replaced in the fall and that didn't help.......
The issue I'm having happens while fishing and leaving the motor tilted all the way down. When I go to fire it back up after fishing a spot (anything over 15 minutes), I almost have to pump the gas...
Did wonders for my Gambler!!
Thanks 1 More Cast! Just dread drilling it out to replace it!
I was finally able to perform some additional troubleshooting on the hesitation issue I've been having. To make a long story short, it appears a mouse may have got a hold of the fuel line over the...
See attached picture of Bow Eye.
Does anyone have an example of what they have done to fill the holes?
I have a 2004 2100 DC and the bow eye has starting pulling trough the hull. It seems like maybe one of the nuts has came off the back. Can you reach the back side to repair it? At first glance, I...
Not sure about the hose clamp, but you can by the correct clamps and the tool from Amazon.
The tool is a Knipex Ear Clamp Plier, which can be found on Amazon.
The clamps can also be ordered on...
Thanks Rich! I'll see if I can get the guy that had the software to take a ride.
Rich, this was just with the key on.
Still thinking it could be the lift pumps......See attached.
Thanks rat502!
Rat0502,
To be honest, I'm not exactly sure what the RPM' were, I'd say just above 5000. As long as I let off the throttle, it would run fine at anything below 65 mph. It's a little sketchy...
Tonyc,
I had Brucato flow test the injectors a couple years ago. The motor has maybe had 25 hours put on since then.
Engine hesitates at around 65-70 mph, once you let off, it will pick back only to fall on its face again. Changed Fuel/water separator filter, clear bowl filter, VST screen, high pressure filter and...
Thanks GPGambler!
Thanks All! Did you torque the nuts?
Question.....
While CRANK69 was detailing the Gambler, he discovered that one of the hydraulic seals was leaking on the steering system. I purchased a seal kit, but it did not come with...
Question.....
While CRANK69 was detailing the Gambler, he discovered that one of the hydraulic seals was leaking on the steering system. I purchased a seal kit, but it did not come with replacement...
What are you guys using for a replacement Tongue Jack? I currently have a 1500# Bulldog that's on it's last leg. I contacted Fulton and Bulldog and they only make a 1200# jack that is secured with...
Thank You Ted!
I have to give a shoutout to Crank68 for the unbelievable work he did on my 2003 2100 Gambler!!
After everyone having such positive reviews here on BBC, I contacted Crank68. He was able to work me...