Search:

Hey Guys

I have a 2016 Etec 150 HO. Instead of the normal trim sound- it’s making a screeching noise it still trims up and down. Is this due to low trim fluid or something else ?

Does anyone have a good product for cleaning up the black rubber that’s non skid ?

same question for the diamond plate metal on trailer

So I had them modify the front end of the trailer. Saved about 18”

99 285PE
2016 ETEC 150HO
dual Pro Series PP
dual 12” HDS Gen 3
bassboatseats.com seats


403339 403346

That’s exactly what Im trying to do. What boat/trailer do you have ?

Good Morning- has anyone had any luck installing a fold away swing tongue on their stratos trailers ?

Does anyone have a homemade plate and grommet setup that looks clean for running hoses through the hull..

I have two sportsman 2 so it will be four hoses total

Yeah I’m going to have to check it out. I’m going to fill up the livewell with the hose and see if I can observe anything

Hey Guys

I am finally going to resolve something that has bugged me for awhile- my port side livewell will fill up with the aerator pump with no problems. Once it reaches capacity- the pump shuts...

Hey y’all- I have a spot on the floor in front of the in floor cooler that flexes a bit right where the cooler is attached to the floor. Should there be any worry that this is a sign of rotting? My...

Hey Guys- I have the pro series II PP- purchased in Feb 2016. I have one pump that seems to hate reservoir caps. I am now on my third cap. Does anyone know why this could be happening ?

I guess in summary if the floor is composite material rather than straight up plywood, a little bounce here and there isn’t the end of the world. My boat has bee garage kept for its life so it isn’t...

Has any one else experienced a soft spot in front of the in floor cooler accompanied by a squeak similar to walking on wooden stairs? The boat is 20 years old but I want to make sure that I don’t...

I went ahead and put my LSS2 to the lower right of my transducer, even added a little bracket for stability. With that said, I would like any feedback where the 2D could be mounted now that the SS is...

It clips around your ignition key switch

Fellow Stratos Folks

Has anyone perfected the location of LSS transducer and normal 2d transducer on this boat, or late 90s models? My current setup can be seen in the below link. My images on...

Did you have the same scenario with the angle in the bench?

Hey yall

I am wanting to replace the seats in my 99 Stratos. I like the ones from bassboatseat.com but I’m
concerned about how the seat mounting area has an angle and that could interfere with...

It appears that could be the issue- I didn’t have the hot foot to the floor. I’ll try that

I have a 2016 etec 150HO. I apologize for not having the model number handy. I previously had a 99 FICT on my boat but repowered with the ETEC. I have the original throttle arm and a hot foot.

A...

Hey Yall

im pretty confident my tank depth is 12.5”. Can anyone confirm ?

Hey Yall

I have replaced My sending unit 3 times in the last two years. The main cause is always that the float some how becomes loose and ends up free in my tank. I am making certain to only push...

Hey y’all- I have a really tricky and confusing situation. The port side of my trailer has my side marker lights, Stratos cut out lights, and taillights functioning properly. However the starboard...

Oh man I was talking about the new Copenhagen garlic flavor...

Any suggestions??? Thanks in advance