If ur porpusing your prolly not giving it enough throttle to get enough Rpms to hold it on plane. With my renegade 19 I just ease the throttle down till the bow raises up then I slam the throttle all...
Type: Posts; User: malachi1364
If ur porpusing your prolly not giving it enough throttle to get enough Rpms to hold it on plane. With my renegade 19 I just ease the throttle down till the bow raises up then I slam the throttle all...
Does anyone know what livewell pump is a direct replacement? Mine had some residual water left in it over winter and froze and cracked and needs to be replaced. Just looking to see if anyone who has...
trying oconomowoc for the first time ever this saturday. Hopefully the wind doesnt play 30mph like they are calling for
What BTM Bass suggested. That reel takes a BEATING and still performs better than some of my top of the line Reels. And if i do end up breaking one its only $30 lol
Fish boy knows where they at :P
Electronics are your friend
not puttin it away this year till i have to break ice to get out there. Been Slammin the smallies
I live on Okauchee and its the same story for me. Specially in Fall. which is why i focus my efforts on Pine Lake for smallies come mid september
or just take the trolling motor off the boat. its not too hard. I do that every winter because i like to keep my electronics in the house over winter
Vince do it on Okauchee!!! Just cuz its in my front yard and i have 1000's of hours on that lake :P
What EuropeanAm said. had to replace cut that section of my wiring out and clean it up and retuck the wiring so it didnt happen anymore
prolly under the fuel tank
that looks like a copy of my boat just the smaller version. You will love it :P
i got a full transmission rebuild on my 95 chevy silverado for $1000 with a 5 year warranty on the transmission from Dunham transmission. They did great work. Not sure about how much it would be for...
should be a 30A fuse by your battery that runs the the power to your dash
and make sure your watching your water pressure gauge too. Dont trim too far out that your water psi drops to far
did you check to see if your relays are still good? that could be your problem
sounds like you just need a lot more seat time to figure out how to drive the boat. Specially with gettin the hydrolic jack plate figured out. My guess is you have your motor way to deep in the water...
when i do it i just drop down off plane to just into gear and as a second or so later i tap the trottle up a second and then back down to neutral and have zero water come onto the back deck. It just...
i run at 6" setback and love it. i think 10 might be overkill
steering being very stiff is probably more that you dont have the engine trimmed correctly for the speed your running. If it steers just fine at low speeds it should steer just like that at high...
^^ cuz Don is the man
Seafoam from my view is designed to run through at one time and be done with it. Not sit in a tank. I have only used it in cars to clean them out and when i do its in the last 1/4 tank of gas (which...
and i really hope you meant 5800 and not 6800 rpm or your motor is gonna go boom very shortly at those RPMS
Im sure there is specific torque specs for all the bolts but when i take my lower unit off and put it back on I just tighten them by feel. if i had to guess it would be around 45-50 ft-lbs prolly?
another thing i see alot of people having problems with is they still use those stupid wing nuts on their battery terminals which tend to not stay tight and give bad electronics problems