Search:

All your units need to have the same software 23.3 if not you get what you got. Update all to the latest.

Yes it will all you do is plug into the black 9 pin connector on your Live and find the Totalscan name in the transducer type under installation. Make sure Channel 2 is turned on.

Stop sonar on all transducers including SS that will get rid of the pulsing. then post a pic of the image if its still not right.

Before you do a factory reset, go to pages/settings/sonar/installation and make sure you have the correct transducer selected in transducer type.

Check the source for depth. Remember if you stop sonar on all transducers other than AT set the source for depth to the AT then it has an element for depth built in and will not interfere with AT.

1st if the TM is back towards the transom then set negative number I would start with 1 for such a small deg.

2nd the transducer on AT should be7 or 8" from top of the TM motor to the bottom of...

You can create a custom screen and if you find the factory Icons( Hold down the Side Image Icon) then pic the one you want they are all there.

The HST WSBL has been around for years and still available. Just replace with same transducer.

Post a pic of your screen, as in screen shot

Go into the advanced settings on the HDS and make sure you have 3 autopilot settings turned on this is all related to the ghost. There might be a forth cannot remember. Also do you have 1.2v software...

You can have power to the NMEA node and still not work since you have a very small network take ea part off and put back on make sure all Tees and Terminators are on tight same with the drop cables...

So no 3D box? then you don't have 3D SS anymore as you cannot connect direct a 3D tranducer. Requires the box to work even on 2D SS.

If you go to the device list on the HDS Live and the Ghost does not show up then you have an issue with your NMEA backbone. When it does not show up that means no Power. Can you calibrate your Ghost...

Does it let you increase the speed and descrease the speed and then it changes the MPH on the pop up control is for you to set then it show the actual from your setting.

ARe you talking about on an HDS screen? or Pop Up Ghost Menu? Speed control, turning are both on the pop up menu under course lock,

The red tab is stop don't touch it there touch is on the menu stop sonar or add a configurable button for stop sonar

have you calibrated the point 1 if yes than do it again if not do it the first time.

Check the data sources for correct source checked, Turn off all stop sonar on sonar, AT and structure scan, To test the ethernet connection save a waypoint on one unit and does it save on the other...

if I am interpreting what you are saying for the time no source goes off it can take up to 2 or 3 minutes for the AT Module to boot up. That is normal

Got any pics everything you have explained is subjective. So provide a pic maybe that will help discover your issue there are so many directions this can take and again you willl be going in circles...

Do you have command link or NO?

whats the issue with out that no one is sure on your question

I bet you never ran your unit in Deep fishing mode with your other transducer either.

Untill we know what transducer you are connecting to everyone will be just guessing

To the OP the Pro comes with Discovery On Board. I will have some differences than the Reveal as the Reveal has Shaded Relief both do depth shading.