I have a 2000 201d viper that one of the flo rites is leaking on. Does anyone have the part number for the new replacement ones?
Thanks
Type: Posts; User: candimancan
I have a 2000 201d viper that one of the flo rites is leaking on. Does anyone have the part number for the new replacement ones?
Thanks
I have a 2000 201d that doesn't have a plug in my cooler. Does anyone know where I can get one or what size I need to get. Thanks for the help.
I've got a Lowrance 9 gen 3 at the console mounted on top with a 6" ram mount with a 1 1/2 ball. I screwed the base a little to the right of center and I have no problem at all. I can't post pics...
I've got some pics of how mine in mounted on my 2000 201d but I can't load them from my phone. One is on each side of my livewell screens. You can text me at 434-942-1310 if you want the pics. Mike
I'd like to know also Tom I emailed you!
I just bought a 2000 201d with a 2012 250 pro xs he said when he first put it on it was pegging the rev limiter and was running 79 easy with 25 pitch tempest but I'm getting ready try a 26 and raise...
I just bought a 2000 cobra 201 I would like to have that wiring diagram if you have one for that.
You will probably have to go to a 23P, tempest is a good prop. I have an older Ranger and I have to run a 22P Tempest.
you can buy them at lowes. I have gotten them from there. they are in the specialty drawers.
My serial # is 1B962744
My 175 merc pro xs beeps once after turning the key on before starting and a few seconds later it beeps 6 times and I'm not running full power. Does anybody have an clue?
hey I have a 93 481v with a new merc 175 proxs with a 6 inch jack plate, send me a pm so we can talk, I would like to compare our setups.
the serial # for the motor is 1B962744.
Anyone know what rpm the rev limiter kicks in on a new 2013 mercury 175 pro xs?
mark not sure about the motor height, but I have a 6 inch jack plate when I got the setup close I was running 5800 or 5850 but that was with no weight just one person. when I added the weight it ran...
Hey u can buy either the push button that has 3M tape on it or u can buy a toggle switch from blue water that u could mount in your dash. If you have a panel that has room u could mount it there. ...
I have a 93 Ranger 481V that I put a new 2013 175 Mercury Pro XS. I am having a hard time getting the setup correct. I need some help with the setup, anyone have any suggestions? Would appreciate...
Just add a small piece of wire to them to run each light to a common area on the boat where u can make your connections. i just bought a pro kit. u can solder the wires together and maybe use like...