Hey guys
went out today motor started fine but then when I trim down it died . I used it yesterday with no issues at all, it has to be trimmed 3/4 way up to start then it’s very jerky. I checked...
Type: Posts; User: andyh31
Hey guys
went out today motor started fine but then when I trim down it died . I used it yesterday with no issues at all, it has to be trimmed 3/4 way up to start then it’s very jerky. I checked...
Hey guys
question I just blew a wheel bearing towing , I was able to limp it to a storage place. I have a question, what size of wheel bearing kit is needed? I am newer to this and never had this...
Sorry here is a picture of the motor
This is what they sent me does this seem right ?
Do u have to bleed it or are they self bleeding?
Hey guys,
First question when i lower my trim it makes like a squeezing sound for 3 seconds then stops, I raised it all the way up and and took the cap off to check power trim fluid filled it up...
Hey Guys
might be a dumb question but im looking at getting a transducer saver and shield, i Think my jackplate is a 6 inch slidemaster but not 100%. I've attached a photo with a measurement of...
150ft max
Hey Guys,
New to garmin i got a echomap plus 73cv but with no transducer, im looking to get one im wondering what you think is best to get with this unit.
Any information would help
So what i did was buy a new one and replace it swapped the housing and tightened it works no problems. But i would recommend is put the cable in first then put the guts into the housing. ...
just got mine it was a 3 valve barbed and front
Hey guys got a 294 pro xl and i think one of my aerator pumps went pumps very low took it apart nothing blocking it. i have a picture just curious if any of you guys know the GPH 411808
Hello,
i got this crack in my gelcoat don't know if its from stress or what happened, ive never done gel coat repair before ( is it easy). Ive message a few places that repair gel coats but never...
Hey guys still newer to lowrance i have a hds 9 and 7 gen 2 linked i have a question i have the basic depth and temp transducer mounted in the hull. I notice on my 2D i mark depth and temp but i...
Hey guys i have a motorguide 112 but when i go through weeds it literally just bunches up so bad. What blade do you guys use to go into heavy veg?
Thanks
Hello , Looking for a little help here Have a hds 9 gen 2 at console and everytime i use my 2d sonar i never see Archs its looks like weeds on the bottom. I know there fish there because ill get them...
Just looked at a 2006 200hp etec has about 300hrs on it. Tryed it out runs smooth, question is 300hrs alot on that model? How much can you typically get out of a etec hrs wise?
Thanks
Hey guys
Looking at buy my first bass boat it is a 2006 stratos with a 200hp evinrude on the back, I already looked at it once and going to test drive it tomorrow. Any recommendations for...
Hey Guys
I'm currently looking at a 2006 stratos xl with a 200 hp evinrude on the back the boat is in real good condition, the motor has about 300hrs on it. Just looking for things I should look...