Search:

Thanks Don. Too bad . Its in mint shape. I wish Merc had made them the same fitment.

What is required to adapt the Verado case to my 250 XS or should I just let it go ? I can get a very low hour one that I was hoping to have as a spare .I have discovered the shift shaft requires some...

I only have 3 photos on my phone of this case so its hard to look closely at it. If it is a Mercury Verado case will it fit my 2004 250 xs ser: OT819564

Do you mean a riveted on tag ? This one just has stamped in numbers 080713 06P321 on top. No tag.

What is best method to tell difference visually between a genuine mercury gear case and an SEI ? I have been looking at a gear case off a 2006 Verado 175 and can't find any mercury emblems on it ....

For what it costs change the red filter on the VST first. Sorry , didn't see that you found a bad coil in initial post.. Still good idea to replace filter though.

That symptom CAN indicate a blown top seal below the water pump that is letting water in. What happens is the water causes the remaining gear lube to float and show up as a leak where the case and...

Hyperflow runs one on his 2002 20 XD with DBR 300 XS 1:62 Sporty to just over 100. It would work fine light on your 21 but might not be the best choice loaded. The 21 is a lot more bow heavy than a...

Fuel pressure shouldn't drop so fast after stall. Pull tracker valve and inspect. Pay close attention that the little brown O ring is there. For the price of the MPR.. under 30.00 change that out...

Allison XB 21 is in a class by itself and all Allisons are built without compromise. Then Bullet , Stroker we are talking build quality , not necessarily ride quality. The Rangers , Phoenix ,...

You would think a leaking valve would progressively worsen . Fuel pressure checks with the proper gauges will isolate it.

Its leaking. My bet is tracker valve or fuel pressure regulator valve. If you've had tracker valve out double check that the small brown o ring was re installed. If that o ring isn't there you will...

Its leaking , fuel regulator valve or tracker valve are likely suspects.

Tracker valve going can do that.

3/4 to 1 1/4 below. Usually 3/4 below with torque master.

I got 88 with my 2002 21 XDC with 250 XS running light with troller off with a 30 performer 4 and a 1 : 75 Sportmaster 1 inch above pad.(video posted on here and youtube)… With it set up to fish...

I now lots will disagree with this . I have tried around 50 props including those listed above and many others on my 21 xdc with 250 XS with both sport master and torque master cases in both 1 : 75 ...

They look a lot like a Moodcraft , especially the purple pic. Is this a redo/rename of the Moodcraft ? Oh .. On closer inspection I see those pics are of Moodcraft Stealth . Sorry.

Mine was doing this and it was the tracker valve.

Yep.

My 2004 250 XS did this when Main Power Relay was bad.

Any updates ? Its been weeks.

Grybirds advice is correct. Remove the cowl and with the boat in the water or on muffs with water and the motor trimmed level , loosen the small cap on the engine mounted oil tank and start your...

I would check the tightness of the nuts on the leads at the motor also, including the fusible link wire . Often overlooked.

Please let us know what it turns out to be.