Search:

If you decide to get a guide check out McCotters, one of the best on the lake.

My niece suffered from migraines most of her life, started in her teens. Hade a ton of tests and diagnosis, turned out to be lupus. Took about 12 years to get it figured out.

I have a BakFlip, sturdy, you can stand on it. Leaks a little though.

508985

I think the bottom cousin just pulls out of the base, it is a tight fit.

Who did you order the kit from?

The AC part does but the DC part uses the ground cable and charges the 3 trolling motor batteries in series.

Stealth chargers use a wire from a trolling battery neg. to start battery neg.

You need an alternator. Low voltage shut the controller down, failsafe.

I got a set from C&O marine.

Is the other part of the thrust washer stuck in the prop?

After the flash I was able to run more prop, better hole shot and picked up 6 mph. Usually don't run it very long at higher rpm, try to keep it around 62-6300. Still pulls hard.

Mine would run 6100 with no problems now after the flash it's turning 6600

Not for me either, used mine twice also and that's it.

serial number and there's a number on the bottom of the pedal that you will need.

469334

I was looking for some Motorguide parts and couldn't find anything local, ended up calling C&O marine in Tennessee where I bought my boat, they were very helpful and I had my parts in a couple days.

My boat has a 2015 250 SHO on it and almost didn't buy it because of that, have only owned Mercury's before this and don't have a good shop close by. I have no regrets now and I love the motor, would...

I work on them, there pretty good besides the 2 issues mentioned we see some cat. converter failures and some cam sensor issues.

All the Bob's plates I have owned had a gauge.

Don't know about mixing the two but you can get stuff to thicken gel into a paste, just google it.

No ramp at National Harbor. Pohick is not far from Marshall Hall at all. My buddy is fishing it and said launch was out of Smallwood in Mattawoman.

I use super glue, worked great.

Saw a add on facebook for a company that makes them, Google it, you will find something.

The metal plate should be screwed to the boat.