I sold a friend my sv 93 and I told him you could get rid of the blocks of numbers on the right side of the screen. I did it on my 93 plus but can't remember how I did it. One other question, he...
Type: Posts; User: doug1542
I sold a friend my sv 93 and I told him you could get rid of the blocks of numbers on the right side of the screen. I did it on my 93 plus but can't remember how I did it. One other question, he...
I just got a notice from Cabelas. They will have the 93sv plus for 599.97 Nov 27- Dec 1. In store and online.
That's what it was Don. The green wire was broken. Thank you so much for the great advice.
2009 Verado serial number 1B734074. It has the big tiller handle on it. The trim switches at the front of the boat and on the side of the motor work fine but the switch on the end of the tiller...
Thank you!!!
Is the verado air filter like a K&N filter that you wash and put oil on or just a regular filter? What kind of oil if you do that?
I have a 200 Verado. Serial number 1B734074. Last week I made 2 mile run and when I slowed down to idle a warning buzzer came on for about a second. I think the smartcraft said system failure. I...
I took it to them yesterday and they said it was the input shaft seal. They put a water pump kit in about 2 months ago. I don't know if that is something they did or not. I told him when I dropped it...
It was the dealer I took it to. I didn't check the level after they did it. I thought they knew what they were doing. I've used it about 4 times since then at around an hour each time. I'll do it...
Looks like the oil is way too high. It is past the hash marks and almost 1/4 inch from the rubber above.
It is blue so I'm going to take it in and have the seals replaced. Hopefully everything else is OK.
I should add that the water temp is 45 degrees. A friend of mine is a dealer and thinks it is what he called motor slobber. The oil has about 1/3 inch left on the dipstick. I didn't check how much...
I have a 2009 Verado 200 L4 Serial number 1B734034. Today when I walked by it I saw it was leaking what smelled like 80w90 out of the water intake holes. Does this mean a seal is out?
I did the sync-N-link. The tach works right now but I am only getting 4600 rpms. I used oem parts. I stuck wire in the passages and sprayed carb cleaner in them, looked like it was blowing through...
I replaced the stator and voltage rectifier and cleaned the carbs. It still is not right. The plunger on the accelerator pump is worn down. The tach jumps around and sometime is buried all the way. I...
Thank you.
I have a 2005 115 2+2 motor. Serial number is 1B185286. It has been running rough at wot. I have replaced the fuel line from the tank to the transom and new hose and bulb with the kind recommended...
OK. I'll see how it goes this weekend.
Thanks for the quick reply Don, The engine was not used for a weekend. I have tightened the connections where I had to remove them to take the engine off. The hose and bulb came assembled from the...
Ever since I took my motor off to replace the transom board I am having trouble starting the motor after a week of not using it. It seems like all the fuel drains out of the line. I have replaced the...