Search:

Okay great! Thanks

Does anyone know of a mount to change a Mega 360 on a Fortrex to mount on a Ultrex?

Who sells the trash master jigs?

Mine did almost the same thing other than it would kick the low voltage warning on the screen! Re ran new 10 gauge wire straight off the battery and no more problems! Your’s is probably going low...

I researched it some about a month ago and I believe the G3+ units put out to much power and will burn up your transducer! I was going to use a Lowrance in hull transducer for high speed that was...

If both graph's don't show a tab for Ethernet. I would be surprised if it's getting power! After I got power back to the Ethernet box then both Graph's showed the Tab and then I could select which...

your Ethernet box has it's own power cables! it must have power for it to work properly

Check the power connection! Mine was doing the same thing last week and when I got home I checked and the main power wire had been pulled apart! After redoing the power now brings the network tab...

Okay thanks that’s what I needed to know!

Okay thanks for the replies! Wayne they list a Helix 10 chirp GPS model and a Helix 10 chirp DI model on their site so go with the DI unit correct? I’m not really a live scope guy. I like fishing not...

Here is what I have: Helix 12 SI G3N at the console and Helix 12 SI G1N at the bow hooked together with Ethernet. I'm purchasing a new Mega 360 unit for the trolling motor (Fortrex with US2 not...

Wayne if I hook up a mega 360 to my console unit(Helix 12 GN3 SI)with this Y-cable will I be able to view side imaging off of my side imaging transducer when I pull the Trolling motor and 360 out of...

I'll look I didn't know there was filters! are they hard to find?

Okay thanks that’s what I needed to know!

I have a Mercury 225 Pro XS serial#1B839973. I just replaced the compressor on it. It snapped the bolts on the pulley on top! It didn’t appear to have broken anything inside but I replaced it anyway....

I was just trying to figure out how to use Mega 360 with out buying a new G3 unit for the trolling motor! I already bought a Helix G3N SI for the console. That won’t work unless I have the trolling...

So Wayne if you used the Mega 360 Y cable on a G3N SI+. You could then get side imaging from the HW SI transducer That came with the unit while idling and then when you stop and lower the trolling...

Thank you Wayne!! I know the spot is good since the Helix 12 Gen 1 HD side imaging transducer used to work up to around 50 MPH in that spot. Unless you made a tight turn in deep water then it would...

Well I guess I will have to lower the transducer and adjust the angle to get a bottom depth. I lose bottom about 20 miles/hour and then get a false bottom reading. Thanks

I don.t mean to take over his thread but I have a similar problem. I purchased a XNT 9 HW T transducer for the transom and a 9 M SIDB Y cable to use with my 12" Helix Gen 3 SI unit for high speed...

Thank you Wayne! That means I will be keeping my standard 360 unit until I get a Gen 2 or 3. Thanks again

So Wayne it will share with a G2 unit but not a Helix 12 Gen 1 si chirp unit?

Thanks

Wayne do they make a bracket for the jack plate to mount a gen 3 side imaging transducer? Thanks

Okay Thanks again!!!