Hi, I have a F60 hp . When I crank have a back fire. It’s a model T60TLR
Thanks 👍
Type: Posts; User: Lunar
Hi, I have a F60 hp . When I crank have a back fire. It’s a model T60TLR
Thanks 👍
I replace the sensor for a new one and clean the hose that goes to the emm but the issue is there!
Is in the trim down position (as normal running position) I was looking for a loose wire for the idle issue that I have! And when I remove the cover I noticed the oil. Thank you
Hi guys, I have my FICHT full of oil at the air silencer box, is a 250 hp 2000 model E250fpxsif serial number GY04931906 . What could be the problem? Right now the engine doesn’t make idle.
Hi, yesterday got mine running back again. Replace the relays but not idle, i have a spare fiuel pump and now is back to normal.
thank you guys for all the inputs.
thanks you!
Ok, thanks for the info, mine has no codes also. But i will check those relays today. I will back to you if its work.
Thank you
Hi, do you slve your problem? Im having the same problem, we replace the exhaust pressure sensor and clean the hose to the emm but the problem continue. What else to look?
thanks
I have a set from V6 1999"
Hi: Wich are the funtion of the blue capacitor on the ficht evinrude motors?
thank you 👍
Hi! Do you have any pic of your ecm? I think that I have one of those and was fixed from DFI, we junk the motor by a blown gear case. My motor is 1999.
Hi, I have a Merc 3.0 225 EFI and we get water in the gas , we drain the tank and replace the fuel filter and take the injectors to service and run the boat when the engine reach the 2000 RPM’S the...
Thank you for your input !! I will check .
Good morning to all ! Yesterday I get a propeller hub goes, the motor goes to a high rpm's and die, now have the check engine light on and blinking but the motor won't crank and the fuel pump won't...
Sorry for your loss.
Hi, ChampioNman! Yes, it is 1991.
Hi to all, im looking for a evinrude v6 encoder p# 0513031 , the part is no longer available from evinrude.
thank you all.
need to remove the flywheel on my evinrude 1989'50hp, I need to get a socket wrench but don't know the size. can any one tell me the size for the socket? please:smile:. thank you...
i'm back, fuel pressure is 25psi, replace fuel line, and find the #7 fuse on the pdp,i relace the pdp and the motor run like new...all these become after one fuel line disconnected from one of the...
hi guys, i fix the missing bolt on the intake manifold and the engine run better, but now die after a minute at 3900 rpm's.
ok, thanks. i will repair that and i keept posting the results...thank's again for all the inputs.
if the engine intake manifold has a commpresion escape from the miss screw can affect the pumps operation either gas or oil pump? and cause the engine to die at higth rpm's?
Yes, the motor start right away and keep running good at idle. i get a pdp today to try it.
yes, the same. we note in the intake manifold a miss screw near one of the reeds valve case and one of the fittings for the diafragm pump connection. you can hear the compression scape from the screw...
We use a portable tank with fresh fuel thinking of bad fuel
We run the diagnostic software and have no codes, the motor run fine at idle up to close 2000 rpm's.
replace the plugs and fuel filters.