I made an order a month ago and received a conformation and a note that there were some delays in shipping and they would let me know when it ships. Well, today I tried to send them an email to the...
Type: Posts; User: wmitch2
I made an order a month ago and received a conformation and a note that there were some delays in shipping and they would let me know when it ships. Well, today I tried to send them an email to the...
Did you mount it on the motor or on the shaft ? If on the shaft, is it facing front to back and not side to side ?
Was the old plug a flat plug or a round plug, and how many pins ?
I've heard you can replace the whole relay setup with a $20 Wench relay from Am....... !
Bradrodfish where are you ???
Sounds like a bad or weak breaker. I'd start first with checking all the connections. Make sure they are all clean and tight. Then replace the breaker if it still does it.
I have 2 UHD 93sv units at the bow. One is for Live Scope and the other is for Chirp/Down/Side scan. Is there a Y-Cable that will allow me to use both units off of one GT56 transducer ??
I found this on Am....... over the trolling motor peddle, high rise and two graphs. Strong and stable in all weather. If I'm gonna make a long run, I can remove the Garmins from the cradles and...
I had a similar issue only mine was wearing on the inside of the tire. I pulled the wheel and noted that the splined end holding the hub to the torsion arm was not "Flat" in the arm mount. I...
It has to be deployed to work !
I've always used a "Snake" of Plumbers Putty and make it just a little larger than the transducer. Holds the epoxy and is easy to remove after use,
Not sure, that's just what my mechanic called it. I'd have it checked before just changing it, it was like $400, so You do need to have it troubleshooted by a qualified service tech.
[QUOTE=Rick H;13456383]To each their own but I hate black wheels. :wink:
YEP !! I agree 100% !! Especially since my favorite color is CHROME !!!
It may be different for the brand of tire, how many plies, etc. It will be printed on the side of the tire as to what #s for that particular tire. The max #'s already accounts for expansion.
HHHHUUUUUUUHHHHHH !!!
They stay pretty much, depending on how rough and on how full the locker is. When they hang without hitting anything they pretty much stay put.
Mine was doing the same thing. Found it was the secondary fuel pump. Replace it and all is good
My 2002, 205vx, 225 Optimax, 6" Jack Plate, 2 axle, Tongue folded, Motor down is 24' 2". I don't think a single axle is any shorter. My garage is 25' deep and it fits no problem.
I made my own with some 3/4"x3/4" Aluminum angle from Home Depot. Just drilled the holes 1/2" apart. Works great !!
Many confuse Flippin' with Pitchin'. Flippin' is done with a length of line that doesn't change in the presentation to the target, Pitchin' is done letting line out as the lure goes out to extend...
I have been thoroughly happy with mine !! They work as intended !! I chose to use Pop Rivets instead of the Bolts that come with it. Just liked the look better.
I've used Emory Cloth or a medium Steel Wool to make it look better. The plastic outer shell is just a covering for the Transducer. As long as the plastic isn't cracked or broken you're good to go...
Funds sent
^^^^^^^^This one !!!
I added a fuse block in the front starboard locker for my graphs and connected a Perko cut off switch for the GLS10 box on the wall towards the console.