Search:

Type: Posts; User: TXZ21

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    20
    Views
    671

    Have been dealing with this issue also. This was...

    Have been dealing with this issue also. This was what I used. I put three of them in the bilge. Probably not a permanent solution, but its working.
    ...
  2. I have heard nothing but good things about them. ...

    I have heard nothing but good things about them. I will give them a call.

    Thank you.
  3. The Apex's replaced Solix's, and they only added...

    The Apex's replaced Solix's, and they only added a total of 6 pounds more than the Solixs weighed. I moved 12 pounds of tackle/gear to the rear to offset that amount. The lithium's were already...
  4. Thanks for thr reply. The boat is seems to be ok....

    Thanks for thr reply. The boat is seems to be ok. Pad looks good, and I didn’t see any place holding water in the bilge. I have run the boat almost out of fuel and refilled with the same fuel I...
  5. Experienced Mercury 2 stroke tech needed for diag. in the Houston area

    I have a 250ProXS serial # 2B399616, on my 2017 Nitro Z21. It only has 216 hours on it. It seems to be running fine. Very smooth, starts immediately on first cranks, hot or cold, gets on pad with...
  6. Replies
    57
    Views
    1,683

    You don't have to eliminate the air suspension. I...

    You don't have to eliminate the air suspension. I lifted mine with a BDS 4" kit and still have all 5 height settings. This pic is in "Off-Road II" mode. Their stuff is great quality, but a little...
  7. Considering a switch to Garmin from Humminbird.

    I've been a Humminbird guy for decades, but I'm considering switching to Garmin. I really like what I've see from them lately.

    I currently run an Apex 16 at the console, and an Apex 16, and an...
  8. Replies
    4
    Views
    172

    I used Oznium's kit, and their small dimmer...

    I used Oznium's kit, and their small dimmer switch so I could tame down the brightness. Their switch is very small so the small hole needed was not an issue for me.

    ...
  9. Replies
    3
    Views
    173

    Same thing my dealer had to do back in 2016 when...

    Same thing my dealer had to do back in 2016 when I put an Atlas on my Z18. Just put the transom tie downs on the jack plate. Only pic I could find of it from back then.
    ...
  10. Replies
    9
    Views
    1,467

    I’ve bought several graphs from Lyalheld and...

    I’ve bought several graphs from Lyalheld and BassBrawl over the years, including one of these Apex’s. It arrived exactly as described, and in perfect condition. Great seller!
  11. Replies
    12
    Views
    639

    Maybe I shouldn't be doing it, but I have been...

    Maybe I shouldn't be doing it, but I have been running this set up for a little over a year now with no issues. 2 Ionic 125ah paralleled running everything, and cranking. Using a MK 550PCL 5 bank...
  12. Replies
    9
    Views
    1,467

    PM sent

    PM sent
  13. Thread: Z21 seats

    by TXZ21
    Replies
    3
    Views
    296

    I think you can still get the original seat...

    I think you can still get the original seat skins/covers from Nitro through your dealer of BPS.
  14. Depends on the "performance standpoint" you are...

    Depends on the "performance standpoint" you are referring to. Speed or electrical power? The electrical power longevity is awesome, but you will need to change the way your boat is set up, and even...
  15. Thread: Nitro Z21 Decals

    by TXZ21
    Replies
    5
    Views
    282

    I believe the original Z21 side decals are only...

    I believe the original Z21 side decals are only made in white or black. Give these people a call. www.domednumbers.com They have made me some really nice stuff over the years.
  16. Replies
    4
    Views
    197

    I run my whole boat, electronics, lights, pumps,...

    I run my whole boat, electronics, lights, pumps, poles, cranking, everything, off of two Ionic 125AH lithiums wired in parallel. That is powering four Solix 12's, Mega 360, and the rest of the boat, ...
  17. That's what she said :wink:

    That's what she said :wink:
  18. I tried lowering the motor on the Atlas jack...

    I tried lowering the motor on the Atlas jack plate all the way down, and them raising it slightly each run to see where the best speed was. It ended up being about 1.75" lower than where I used to...
  19. I have a 26 Tempest plus that I haven't tried...

    I have a 26 Tempest plus that I haven't tried yet. I assumed it was too much wheel. You think it may work? I have what seems like a garage full of props, but just keep running a 24 Fury 4. I have a 1...
  20. 2017 Z21, anyone ever run larger than 12" jack plate on this hull?

    My 12" Atlas is starting to give me issues. Was considering replacing it with a black Bob's action series. I was looking a 12" or 14". I have been struggling with lack of bow lift ever since I...
  21. Looking for a price please, shipped to 77054, ...

    Looking for a price please, shipped to 77054, for a 14" Bob's black Action jack plate, with gage kit and NMEA gateway.
  22. My boat came with two of those

    My boat came with two of those
  23. Thank you. I thought about going with the 100ah...

    Thank you. I thought about going with the 100ah TM batteries but so far I have never seen the 50ah go below about 55%, and that was after 8 hours of spot lock on a windy day.

    These are the...
  24. My boat is a two stroke so may be a little...

    My boat is a two stroke so may be a little different than yours, but I went to 5 lithium's. Lost a ton of weight from the back of the boat and still trying to figure it all out. this is the set up I...
  25. Replies
    11
    Views
    588

    I can tell you that switch in my 2017 Nitro Z21...

    I can tell you that switch in my 2017 Nitro Z21 was not wired correctly from the factory. The entire jump start system was wired wrong. Chased the issues for weeks before just removing the entire...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4