I tried a few more cuss words and got it right! :) Thanks for the pdf and links, though.
Type: Posts; User: Luckykjarmz
I tried a few more cuss words and got it right! :) Thanks for the pdf and links, though.
I had to replace the tilt/trim switch on a single handle, side mount, BRP throttle control and now I am struggling to reseat the throttle handle in the right position. I don't have the model number...
Thanks. I was hoping not to do a full restore but if that is the answer, so be it. Yes, definitely need to hear the click on that Y adapter connection.
What is correct transducer setting selection to make with Helix 12g2n? I have recently lost the 2d dual beam frequency setting on my unit, so I am wondering what is the standard transducer setting to...
Anyone have a photo or diagram for the optimal transom installation location on a Ranger Multi Species hull? The standard installation manual is vague and does not depict the design of the transom...
Thanks for your interest and help.
I didn’t check that yesterday out on the water, but it is rolling just fine as I sit here in my garage. Outside temp yesterday was 30-36F for the 6 hours we were out. Had the issue right from the...
385447
Direct tie into console circuit board which is fed by 12g wiring from fusebox (5amp fuse for the electronics). Not sure what gauge wiring runs from the fusebox to the 12v batteries but it is all...
Thanks. I suspected so, but wanted to make sure there was not another potential issue. Adjusting transducer position today.
Just replaced a Helix 9 SI unit with Helix 12 unit at my console. On first test drive, the transducer is mapping AC live data at low speeds but I lose AC live and all previously mapped data on my...
Just installed a new Helix 12 g2n SI Mega Chirp unit. This replaced a Helix 9 SI at my console. I am experiencing a long delay (up to 3-4 seconds) in moving between or selecting menu functions. Any...