Search:

Type: Posts; User: straffordengineer

Page 1 of 16 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    295

    Why don't you want to rebuild it? They are...

    Why don't you want to rebuild it? They are simple to rebuild and much cheaper than a entire fuel pump. I always get to long bolts to assemble the pump parts on. this keeps everything aligned. ...
  2. Replies
    10
    Views
    601

    I removed my MDI transducer from my Ultrex since...

    I removed my MDI transducer from my Ultrex since I needed a Garmin transducer instead of a Hummingbird transducer. It was not that difficult. I don't know why Minn Kota says it can't be done. I...
  3. I had an Ultrex with a MDI transducer as well and...

    I had an Ultrex with a MDI transducer as well and had no room to mount an external transducer. I simply replaced the nose cone (with the built-in MDI) with a plain nose cone from a Terrova. I had...
  4. I have had my 93sv fall out of the cradle before....

    I have had my 93sv fall out of the cradle before. It is mounted to the right of my steering wheel. I caught it just as it fell out and was heading for the water. Turns out I was not fully seating...
  5. Replies
    2
    Views
    129

    Networked Unit Updating Slowly

    I have a Garmin 106sv networked with a Garmin 93sv. The 106 is at the bow and the 93 is at the steering wheel. When using the fishing chart on the 93sv by itself, the chart works great. When I use...
  6. Replies
    53
    Views
    2,976

    I agree but the Carlisles were almost half the...

    I agree but the Carlisles were almost half the cost of the Endurance. I figure it was better to buy 2 sets of normal priced tires instead of one set of very high priced tires. Based on the amount of...
  7. Every Ultrex, Fourtrex, Terrova, and Ulterra...

    Every Ultrex, Fourtrex, Terrova, and Ulterra schematic I looked at shows the bearing, a thrust washer, and 2 Bellville washers. The thrust washer is part number 990-045 and the Bellville washers are...
  8. Replies
    3
    Views
    579

    wire could range from #8 to #2 depending on the...

    wire could range from #8 to #2 depending on the motor thrust rating and the distance between the batteries and the trolling motor.
  9. Mike, I also identified just a plain nose cone...

    Mike, I also identified just a plain nose cone without a transducer for a 4" motor Terrova (421-276). The illustrated parts list indicates a 9421-287 or a 421-276 fit the 4" Terrova so since the...
  10. Thanks, these videos were very helpful.

    Thanks, these videos were very helpful.
  11. you can’t buy the Hummingbird transducer nose...

    you can’t buy the Hummingbird transducer nose cones separately but you can buy the standard US2 nose cone. $87.
  12. I received a response back from Transducer Shield...

    I received a response back from Transducer Shield and Saver. It doesn't sound like anything I am interested in. The complete set-up will cost almost $200. $110 for the Garmin transducer bracket...
  13. I have the MDI transducer. I looked on the site...

    I have the MDI transducer. I looked on the site you mentioned. I did not see what you are talking about. There is only about 3 inches of clearance behind the MDI transmitter. I don' see how it...
  14. Replies
    53
    Views
    2,976

    Don't buy Goodyear Marathon. I have had 3 sets go...

    Don't buy Goodyear Marathon. I have had 3 sets go bad within 3 years and I only drive about 1200 miles per year. Same problem happened on all 3 sets. The belts shifted internally and made the tire...
  15. Replies
    52
    Views
    2,417

    I have driven Chevy's for 45 years now and I...

    I have driven Chevy's for 45 years now and I would recommend a FORD. You couldn't get me one of the new Chevy's with Active Fuel management. The Chevy's might get a little more mpg but if you plan...
  16. Ultrex Built-In Transducer Modification

    I have a 2020 Ultrex that came with a built-in Hummingbird MEGA transducer. I bought the trolling motor used (like new) for $1400 so I couldn't be picky about the transducer. Unfortunately, I don't...
  17. Replies
    3
    Views
    373

    For slight bends, I have used blocks of wood and...

    For slight bends, I have used blocks of wood and a C clamp. You need to bend the skeg past straight or it will go right back to the original position. the key is not to get too aggressive. Bend it...
  18. Replies
    14
    Views
    1,025

    What do you mean by "reversed" a cell or two. I...

    What do you mean by "reversed" a cell or two. I don't see how a discharging a battery can reverse a cell.
  19. Problem with Minn Kota Edge Trolling Motor

    My Minn Kota Edge trolling motor is acting up. It has a know to control the speeds. It is a 5 speed. Speeds 3, 4, and 5 work fine. However, Speeds 1 and 2 operate at full speed. What could be...
  20. The only reason that would cause the linkage rod...

    The only reason that would cause the linkage rod to flex is the carb is binding up and not rotating. You indicated that the carb will open 100% if you open it manually. Therefore, I don't think you...
  21. what kind of problem are you having with WOT?

    what kind of problem are you having with WOT?
  22. 2004 Chevy Silverado Down Shifting

    I have a 2004 Silverado with a 4 speed tranny and a 5.3 engine. I love the truck but I hate towing my boat with it. If I keep the cruise OFF, it will do fine and I get about 13 mpg. If I leave the...
  23. Adding an External Transducer to a Motor Guide Xi3.

    I am not satisfied with the built-in transducer in my Motor Guide Xi3. I know I can always strap my original Lowrance transducer (which works so much better) to the outside of the Xi3 shaft but I...
  24. Replies
    4
    Views
    349

    I didn't see where you changed the fuel pump...

    I didn't see where you changed the fuel pump diaphragm. You are either losing spark or fuel when you get to higher rpms. Don't know why it isn't starting right now. You need to determine if you...
  25. Looking for a GPS Trolling Motor

    I am wanting to purchase a GPS trolling motor. I don't want to spend an arm and a leg but I want one that will work well. I am mainly just wanting the Anchor (spot lock) feature. Based on my...
Results 1 to 25 of 384
Page 1 of 16 1 2 3 4