My 21 Skeeter with 225 sho has a 12inch Atlas plate and the motor is not even close to any of the bolts clearance wise.
Type: Posts; User: mknj671
My 21 Skeeter with 225 sho has a 12inch Atlas plate and the motor is not even close to any of the bolts clearance wise.
2021 ZX225, I have full lithium batteries, Ultrex 112 52inch and stock graphs on the boat. Myself, full tackle, 1/2 tank of gas in the right conditions I have seen 73.4. Majority of the time with...
My garage is a little under 24 feet with door being inset a bit and my ZX225 barely fits. I have about 4 inches behind back of motor and maybe 2 in front, tight squeeze but the Skeeter numbers are...
Another vote for Amsoil, been running it for a very long time in my boats, motorcycles, trucks/cars and never experienced any problems.
Had a 2014 and now a 2021, only thing I do not like about the newer trailer is the bunks and obviously boat seem to sit much higher. Loading and unloading on ramps where there is not a significant...
Mine on my 2021 was messed up at the very front straight from the factory. Dealer noted it and Skeeter installed a brand new one when the boat went back for gelcoat issues, not sure why the dealer...
Likely the internal sub valve assemblies causing the issue, my 21 225 had the same problem and they were replaced under warranty - no issues since.
On my previous Zx190 it was mounted under drivers seat but to the floor, never had any issues with it. On my zx225 they decided to mount it inside first starboard compartment floor up against divider...
Same here, full Ionic setup with 125 starter since beginning of 2022. Had one issue with graphs shutting down early on when battery was at 100%, talked to Drew and he had me draw down and recharge...
If your graphs are Gen4 it only requires one cable to the console unit, if you have an ethernet network already you can also connect it that way.
I had mine moved down one hole after going to all lithiums, care to share how you did it at home?
Guess I am lucky, my 2021 225 sat on Champlain for a week in some pretty bad downpours and none of the compartments outside of center cooler got any water in them. On the way home we hit massive...
The perko latches and normal wear have taken off the black powder coat in more than a few spots on my boat. Was looking to touch up the areas with some spray paint, stock coating looks like semi...
Flitz or Meguirs metal polish should take that off with a little elbow grease.
Next up best oil brand.
On TZX you could get to them from compartment in front of console - the wiring was tucked behind panel separator.
The older TZX190 had the power wire for compartment lights tucked in front of console. Not sure if new zx150 is the same but I purchased lights and hooked them up, turned on using same switch that...
I was looking to do this with my 2021 since everything is displaying through NEMA except the trim. Can you post up a picture of the two wires you connected in the motor to get the trim value...
Been using it along with their marine outboard oil in my 2014 150 SHO and now my 225 SHO, zero issues. Just changed lower gear oil that was run all last year and it came out nice and clean, they...
The valve assemblies likely need to be replaced, had the same issue with my 2021 and that is what they needed to do.
It needs 2 - part #: 63P-43802-21-00
Very nice, love the Skeeters with blue in them!
If the dealer will not cover it I have a spare gauge from my 2021 ZX225, I moved to the digital through NEMA. Willing to sell it at a reasonable price so let me know if you are interested, shoot me...
Did you modify the gas cap?
If not leaking externally it is caused by the sub valve assemblies - my 2021 did the same thing.
63P-43802-21-00 2.00 VALVE SUB ASSY
My 2021 with T2 worked by Croxton is normally 68-69 with two people, 1/2 tank/, full tackle but I do not have poles. It has a hydraulic plate and when I spoke with Mark he said to shoot for 2.5...