Search:

Type: Posts; User: HVAC86

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    188

    yes 100% said 5/16. Ive installed then...

    yes 100% said 5/16.

    Ive installed then without the well but. In my lower unit it literally serves not purpose on there as it dosent have the room to swell. I’ve dabbled a little blue loctite on...
  2. Replies
    5
    Views
    188

    Mercury high speed scoops... help

    0G940463

    mercury part 17280A2

    So i drilled the 5th hole to 5/16 per instructions, just it enters past the pick up hole, there’s a lot of meat back there, especially the casting around the...
  3. Replies
    18
    Views
    520

    I took out my voltage gauge and installed the WP...

    I took out my voltage gauge and installed the WP gauge there. I use my graphs to read voltage.
    raising the motor did intact help me. Better hole shot, better handling and a slight gain in speed....
  4. Replies
    7
    Views
    482

    Thanks! This is what I was initially thinking. I...

    Thanks! This is what I was initially thinking. I appreciate you staying on topic!
  5. Replies
    9
    Views
    177

    No limiter on this one.

    No limiter on this one.
  6. Replies
    7
    Views
    482

    Not sure how long it’s been an issue, been like...

    Not sure how long it’s been an issue, been like that when I got the boat
    no leaks
    Am bleeding by keeping quart reservoir vertical feeding into helm, have 2 clear 1/4” tubing running back to quart...
  7. Replies
    7
    Views
    482

    Well the reason I’m asking, if there is a...

    Well the reason I’m asking, if there is a definite answer as to where the problem lies, I can just order a new helm or new cylinder and fix it my self in less than a few hours.
  8. I’ve fished in ga for 20 years and was checked by...

    I’ve fished in ga for 20 years and was checked by the GW once. Same hunting, 20 years once. Our DNR dosent do squat for our fish and wildlife. They only spend their money on revenue items. The...
  9. Replies
    7
    Views
    482

    Uflex steering issues

    Not sure which is the appropriate forum, but I have a Uflex hydraulic steering, how could I diagnose a helm pump vs cylinder issue? I have bled the system extensively, I’m getting no air from the...
  10. Replies
    4
    Views
    126

    Not immediately after, but after 2nd attempt I...

    Not immediately after, but after 2nd attempt I reprimed and still not sifferent
  11. Replies
    4
    Views
    126

    Carb 200 fuel starvation on take off

    OT391189
    Motor was running fine until I made a prop change on the water. Was tiled up to ear max. Swapped props, then on take off it was starving for fuel. I could choke it, (via enricher) and boat...
  12. Replies
    9
    Views
    177

    boat should have lost a couple hundred lbs...

    boat should have lost a couple hundred lbs removing all the wet foam and wood. Also everything was put back using biaxial cloth vs chopper con construction. The 23 turns more like a 25. It is...
  13. Replies
    9
    Views
    177

    97 blazer 190, propping

    Just completely rebuilt the boat, stringers, transom, floor the whole 9 yards.
    Previous owner said he couldn’t run over 62 mph with boat.
    the old motor I also found a bad cylinder, now has a much...
  14. Replies
    5
    Views
    280

    Yes

    Yes
  15. Replies
    5
    Views
    280

    2001 mercury 200 part out. Carb motor

    Have everything but lower unit.
    Has newer electronics, not the switch box style.
    have brand new head bolts for O-ring heads never torqued, just finger tight.
    heads good condition
    block has 1...
  16. Replies
    14
    Views
    280

    52 mph and 21 tempest ain’t bad, these motors...

    52 mph and 21 tempest ain’t bad, these motors have 1.92 gearing. Honestly a 22 bravo 1 fs maybe a good prop option. It’ll probably run same Rpms as 21 tempest but will run higher. Just watch your...
  17. Replies
    18
    Views
    520

    These boats do not like extra weight not 1 bit....

    These boats do not like extra weight not 1 bit. They’re very very inconsistent hulls too! My first hull, ran 64 mph 2 people minimal gear 12v trolling motor. But that hull only lived 3 hours on the...
  18. Replies
    1
    Views
    151

    2.5 power compatibility

    0T391189

    2001 200 CXL carb motor.
    Have opportunity to buy a fresh 2.5 year 1994. Main difference I know is this is a head gasket setup vs mine is Oring heads. I know they will bolt up fine, but...
  19. Replies
    2
    Views
    161

    Source for 2.5 200 powerhead

    0T391189

    Found a scarred cylinder current engine. Just completely rebuilt boat, going to run as is and start budgeting for a new powerhead. Any good reliable sources? Preferably one that doesn’t...
  20. Replies
    14
    Views
    280

    I wasn’t referring to your suggestion of “below...

    I wasn’t referring to your suggestion of “below pad” when I said it wasn’t a pad hull. I’ve got a tracker that’s pretty flat and tried chasing bow lift.

    Can you achieve full trim and feel like...
  21. Replies
    14
    Views
    280

    I betting this isn’t a pad hull. Probably going...

    I betting this isn’t a pad hull. Probably going to run pretty flat. Not sure there’s a whole lot you can due to gain much bow lift
  22. A lot! The shooter is a terrible design and they...

    A lot! The shooter is a terrible design and they run light on pitch. Turns more like a 25 than a 27. Blade geometry and diameter play a factor in the hp need to turn a prop to a certain rpm.
  23. Replies
    2
    Views
    353

    Speed and boat condition

    I’m 95% done on my blazer 190 rebuild. I bought the boat cheap knowing the problems I faced. Drivers side stringer was completely mush, passenger and center were half good. All the foam soaked,...
  24. Replies
    19
    Views
    1,553

    Any new progress?

    Any new progress?
  25. Replies
    5
    Views
    417

    View Post

    2016
    dual console
    150 4s
    3” Vance Jp
    3” PTP
    24v motorguide
    24 tempest plus solo 62 mph 56 loaded but Rpms to low.
    23 tempest plus 59 solo. 55 loaded
    23 bravo 1 FS 55 solo or loaded no weight...
Results 1 to 25 of 78
Page 1 of 4 1 2 3 4