Search:

West System epoxy!

Resin will be soft a year from now. Epoxy penetrates, seals and dries! http://www.bassboatcentral.com/boardstuff2/pimp2.gif

What has been spent on this transformation so far?

Just overlay the old transom with a new 1/4 inch thick transom plate, bolt it together with 5200 and run like the dickens till the ducks quit flying! It can be formed out of a single sheet that...

Pics would be super great.

I'm facing this same challenge, but will wait till winter to dive in.

Mine was caused by a rather great fisherman but as well rather stupid when it comes to...

I've got a 94 boat had a 150 EFI on it. Ran great!

Fuel was taking it's first plunges, or rather soars spring of 04, ran into a deal I could not refuse and repowered my boat with an 04 Opti...

And if a cold front moves through...

http://h1.ripway.com/Waterbaby/Folder%20Name/Leyba/Captncoy1.jpg

http://www.bassboatcentral.com/boardstuff2/pimp2.gif

Nothing against a crock pot, but you can use your oven and consume less energy!

I sued to use a crock pot for my beans, but no longer, in the over just barely bubbeling about 225 setting, 8...

A spin off

Somewhat equal parts of Dijon, brown, with a little yellow mustard and mayonnaise. Add a few shakes of Dash or lemon pepper. (hides any bugs)! :)

It can be done in oven or on the...

http://www.texasbbqrub.com/albums/HH06/100_0164.jpg

http://www.texasbbqrub.com/albums/HH06/100_0104.jpg

http://www.texasbbqrub.com/albums/HLSR2005/DSC_0214.jpg

...

TesasBBQrub.com

A most excellent product.

http://www.bassboatcentral.com/boardstuff2/pimp2.gif

TowMaster will provide about the same performance as the Marathon's.

I've gone through probably 4 sets in 10 years on my tandem of Marathons.


I'[m more than sold on the value of a REAL...

"I'll have my wife measure my package tonight.... "

I'm gonna have the G/f check it out first!! http://www.bassboatcentral.com/smileys/roll.gif

Then the wife can have seconds, bet there is a...

"You are not running in windy chop, but the lake was flat tore up with boat wakes in every direction. "

Copy that, try Lake Powell's verticle walls 1/2 mile wide and every kind of boat one can...

"Take the transom saver off and trim the motor all the way down. This will allow any water to drain and no more to collect in the lower unit. Otherwise, it can freeze and crack the lower unit case....

Modern tires will not get a flat spot or rot over a winter. You can without harm protect them from the sun, but most will wear out prior to any real damage from either the
ground or the sun.
...

There is always a chance of damage when you strike an underwater object.

BUT these things are tough and I do mean tough. They work well for us here and for good reason, they are sold around the...

Drain water as needed, replace cartridge every few hundred gallons.

Mine has been on for 4 years now. Will probably change it this spring. http://www.bassboatcentral.com/boardstuff2/pimp2.gif

There are times that a hotfoot would be nice, but running Lake Powell's expanses is not one of them.

Real rough running, would enjoy it, short runs all the time, same. Long runs.. up to or over...

777 is a 3M spray on contact cement. That is what I ended up using on my entire boat as it was easy to use, convenient to use and did I mention easy to use?!!!

Holds like iron. Buy a bunch of...

Warranty=Sorta like making me whole ASAP after YOUR product fails aint it?

OB's d not require removal from the boat to have a PH replaced, yes it's easier, but such is between the customer and...

"this was after taking my "dolphin" off the motor."

Which had zero effect on your challenge. With a 115, I'd put them back on! BTW, fins are for enhancing hole shot and slow planing speed, once...

The hulls are basically the same if not exact duplicates with an alternate topside design.

so jack plates are as possible and suggested for them as well. Jack plates places the motor into a...

largemouthlou is in that pic on the edge, I'd not call such on the pad, but daaum! He it way up!


Rooster tail no higher then the cowling.

Most bass rigs today are of a hull design called...

Bass rigs, 48-50" is fine and actually quiet long. Anything above requires one to alter the position of the motor in the motor mount.

Yes different lakes can and do require a diggerent depth...

1/4 inch should work fine.

I had an experience with my 94 procraft many years ago. The guy I purchased it from had actually used some non ss hardware to fill some holes he drilled as he totally...