Search:

ice

on my 98 it was a plug in bulb like a license plate light bulb. replaced just the bulb with an led

i used the non tapered

i used the one that comes with 2 bushings in it, its in the customers also viewed this in your link. also i found it cheaper thru first choice marine

thanks i ordered it all yesterday

there use to be a discussion on here on which repair kit from springfield to use for the seat post holes. does anyone rember the part number, also are the seat posts the springlock with or without...

Ok thanks. I guess when everyone says the cleaned their map sensor that's what they actually did.

mariner 200 efi 0g740194 i want to clean the map sensor and from what i can tell it is in the ecu. do i open up ecu and remove or just shoot carb cleaner thru hose to it.
thanks.

Ok thanks for all the replies. I wasn't sure if the timing numbers needed to be changed due to the oil injection and associated electronics removed. Thanks again

The tech book doesn't state because oil injection has been removed. I may have screwed up on before and or after but the degree for low idle and high idle is what I am after. Thanks

0g740194. 98 mariner 200 mag efi
Oil injection system removed. What should my low and high timing be set at. The sticker on the vst says 4 before and 22 after. Is this correct. Thanks

there is an ice cream truck that runs around town with a big sign on the side that says we accept ebt cards

Ok. Does anybody have a part # and know where I can purchase

0g740194. Mariner 200 efi. Replacing the trigger and I have yo pull flywheel. Is there a special tool or will a gear puller work. Thanks

I put enough oil in to cover 48 gallons. Thanks

I have a 1998 188dc. How large is my fuel tank. No storage or cooler between seats. I thought I read somewhere it is 36 gal. Deleting my oil system and going pre mix so I really need y'alls help....

checks in the mail!!!

I am getting a credit card to help raise my credit score and my question to all BBC experts is: is it better to fully pay off credit card each month or leave a dollar or 2 on the balance? I dont...

the electric fuel solenoid on the carb is messed up and flooding engine. i had the same problem. i did away with mine

I have a 98 mariner efi 0g740194. I am looking at replacing my motor mounts with solid mounts. I do hit some stumps occasionally at idle. Has any body had experience with these mounts under similar...

The Kings Bait and Tackle

with engine running at idle or above 1200 rpms?

i used sieera marine regulators. all battery connections are clean and on the nut side of the connector with lock nuts. all connectors are good

reposted to correct forum

serial # 0G740194 1998 200 mariner efi rebuilt in 2006. About two weeks ago i went fishing,everything running as normal, run about 10 mins down the lake and began idling, let off foot feed and rpms...